Model #3627345892 KENMORE Range (gas)

  • Gas And Burner
    3 Results
  • Control Panel And Cooktop
    3 Results
  • Body
    3 Results
  • Door And Drawer
    3 Results
Find part by diagram >

Question and Answers

Q:

My kenmore oven smells like gas when its on

A:

I can definitely understand your concern on the gas smell coming out of your Kenmore oven. I did some research on the problem and provided a link to a similar question and answer on our site. I hope this will shed a little more light on the issue until the Expert responds to your question in more detail within 24 to 48 hours.

Read More
Julio -
August 28, 2012
A:

Thank you for the question about your Kenmore gas range/oven model 362.7345892 that smells of gas when in use. I will be glad to assist with this issue.

First and foremost anytime you smell gas it is suggested that you call your local gas company after vacating the premises. Gas leaks should only be checked by a professional.

Because you only smell the gas when the oven is on, the problem could be a loose connection at the outlet side of the gas valve, or the burner assembly is not lighting completely. I strongly suggest calling for service in this instance.

Thanks Ron H.

Read More
Ron H -
Sears Technician
August 29, 2012
See more answers
Q:

how do you install replacement part WB2X9154 ingniter model 362.7345892 kenmore gas oven. the original part WB13K0004 they are not the same thanks

A:

Substitute replacement parts can raise questions when the wires or connectors do not match up. I located two links that may help. The first link has install directions, the second link addresses the connector problem. Hope this information helps.

Read More
Barbara H. -
July 28, 2011
A:

The second link for a previous answer that Barbara H. posted in the above response should help you connect that replacement igniter.

Be sure that you have the range unplugged when accessing internal components.

The igniter normally comes with a couple of ceramic wire nuts. If you cannot cut off the connectors and attach the wires using those nuts, then you may need to splice in some extensions on the wire harness using some additional ceramic wire nuts that you can obtain at your local hardware store or electrical supply store. If you need more help connecting that igniter, reply with additional details and we will try to assist you further.

Read More
Lyle W -
Sears Technician
July 31, 2011
See more answers
Q:

How do you replace a bake igniter in a Kenmore gas stove model 362.7345892?

A:

In order to remove and replace the bake igniter will require removing the oven floor. See image below.

  1. Disconnect the power cord from the power source.
  2. Remove the two screws at the back of the oven floor.
  3. Raise the rear of the oven floor, slide it backwards and then raise the front out of the channel and remove oven floor.
  4. You should be able to see the oven burner and igniter. If there is another panel preventing you from accessing the burner and igniter, remove it too.
  5. Disconnect the bake igniter harness plug and remove the mounting screws securing the igniter to the bake burner.
  6. Reverse the procedure to install the new bake igniter.
NOTE: The igniter is very fragile, handle it like eggs and do not touch the portion that glows red or you could shorten its life expectancy.

Read More
Joey S -
Sears Technician
July 27, 2009