Model #3627345192 KENMORE Range (gas)

  • Gas And Burner
    3 Results
  • Control Panel And Cooktop
    3 Results
  • Body
    3 Results
  • Door And Drawer
    3 Results
Find part by diagram >

Question and Answers

Q:

Replacement clock for Gas range model 362.7345192 362.7345192 Kenmore Gas range

Q:

Self cleaning gas oven.

A:

I am sorry that you are having some difficulties with your range and I will be happy to help. I did some research and I was able to find a link that will provide you with some good information. I hope this helps with your range troubles while you wait for your expert response.

Read More
Joseph P. -
September 08, 2012
A:

If you already turned the oven selector knobs to the off position then you likely have a problem with the door latch assembly or the door lock switch. That switch will not allow the door to open until the oven is cooled down. Since it has been 24 hours, your oven is apparently cool. If the switch is defective, then it would not allow the oven door to unlock. I recommend that you have a service technician examine and repair the range. Here is a link for the Sears Service website: Sears Home Services .

If you want to fix this problem yourself, reply to this thread and we will assist you with diagnosis and repair.

Read More
Lyle W -
Sears Technician
September 10, 2012
See more answers
Q:

Why is my Kenmore gas range not working properly?

A:

Only the top surface burners need the converted orifices. The bake & broil burner orifices stay the same & are adjusted with a wrench for LP or back to natural gas. The oven regulator has an oven gas shut-off lever that needs checked; the lever should be pulled up to open. Other testing will depend on what the oven does when you turn it on. Does the igniter come on for either the bake or broil? Is the oven clock set for a delay or self cleaning cycle? If the igniters do not come on we will need to use a meter & check the voltage to the igniters. Please see the image provided that explains how to check the oven regulator. If you have a meter & decide to make some checks I have included the tech sheet in the images below.

Once you get the oven working you can adjust the flame for natural gas by turning the orifice counterclockwise until the flame is at the proper height. The flame tips should reach just to the edge of the flame deflector.

Read More
biker dave -
Sears Technician
August 19, 2009