Model #358794744 CRAFTSMAN Blower, Gas

  • Scroll/handle/fuel Tank
    3 Results
  • Muffler/crankshaft/crankcase
    3 Results
  • Vac Bag/tubes
    3 Results
Find part by diagram >

Question and Answers

Q:

Vac 358794744 Craftsman Blower/vac

A:

Tim,

 Below is a link to the owner's manual for this blower (358.794744)

http://www.searspartsdirect.com/partsdirect/user-manuals/358794744-craftsman-parts-blower%40SLASH%40vac-manual?pathRender=fromManualTabPage

Pages 6, 7, & 8 will explain how to use your blower as a vacuum.

Thanks
GClem 9680

Read More
Gary9465 -
Sears Technician
November 09, 2015
Q:

I am installing an ignition module in my leaf blower, model # 358794774. What is the spacing between the module and the flywheel? 358794744 Craftsman Blower/vac

A:

Thanks for using SearsPartsDirect.com, and for being a valued member. 

The air gap on the ignition coil is .010" - .012". To set the proper gap, you should use a feeler gauge. Outside of the gauge, the gap is about the thickness of a standard business car.

I hope this helps, and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
September 27, 2014
Q:

Engine hesitates when trigger is pressed 358794744 Craftsman Blower/vac

A:

Check the fuel lines to make sure they are not pinched, cracked, or broken. If the fuel lines look good, you may just need to adjust the air/fuel mixture screws. Most models have screws on the carburetor that cannot be adjusted without a carburetor adjustment tool (EPA regulations). If you can adjust them, you'll need to turn in the one marked "L" about 1/8 of a turn. If this does not do the trick, you'll need to turn both screws all the way in and then back each of them out 1.5 turns and then start the engine and fine tune from there. Start with the high speed screw (and machine at full throttle) first and then adjust the low speed screw.

If you cannot adjust the screws or there are no screws then you'll need to take the machine in for service or replace the diaphragms in the carburetor.

Thank you for using Manage My Life!

Read More
Wade_B -
Sears Technician
October 22, 2013

Top Parts