Model #358360170 CRAFTSMAN Chainsaw, Gas

  • Chassis/bar/handle
    3 Results
  • Cylinder/crankcase/crankshaft
    3 Results
  • Carburetor #530071603 Zama W-14
    3 Results
Find part by diagram >

Question and Answers

Q:

engine idels won't run chain 358360170 Craftsman Chainsaw

A:

Thanks for the inquiry and for being a valued member.

I am sorry to hear of the issue you're having with the chainsaw. I know how frustrating that is.

This sounds like an internal blockage in the carburetor that starves the engine of fuel under load. The engine can idle fine, but once under load (chain engaged), the blockage restricts fuel and the engine dies.

There is a carburetor rebuild kit, but due to the cost of the kit and the replacement carburetor, I would recommend just replacing the carburetor. That way it would have new diaphrams as well and be ready to install. The part number is 530071603.

I hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
June 14, 2015
Q:

fuel line routing on Model # 358360170 CRAFTSMAN Chainsaw, Gas 358360170 Craftsman Chainsaw

A:

Thank You for choosing Sears PartsDirect.com and being a valued member. It is unfortunate to hear that you are having issues with your chainsaw and I do understand your frustration. Glad to help out. I'm looking at your model number 358360170 and here is a link for a video that will help with the repair.   Just click the blue link above to be taken to the page. I trust this information will help you.

 

Thank you for choosing Sears PartsDirect.com.

Read More
Sherman_G_Wallace -
Sears Technician
January 27, 2015
Q:

gas lines 358360170 Craftsman Chainsaw

A:

Thanks for the inquiry and for using SearsPartsDirect.com.

The smaller line has the filter attached to the end of it. It should be long enough for the filter to lie on the bottom of the tank. It comes out of the tank and goes to the carburetor. The other line comes from the carburetor to the trimmer. Then from the primer back to the tank. This line only goes into the tank about an inch.

Trim the fuel lines at an angle then push them through the hole from outside the tank. Reach in through the fuel cap hole with needle nose pliers and grab the lines to pull them through. Once you have them pulled through, trim the ends straight again and then take up any excessive slack you have in the lines and connect them up.

For convenience, I have added an image below that will help you with the connections.

Hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business.  

Read More
Jeff Wallace Sr -
Sears Technician
October 29, 2014
A:
Jeff Wallace Sr -
Sears Technician
October 29, 2014
See more answers

Top Parts