Model #358350461 CRAFTSMAN Chainsaw, Gas

  • Chassis/bar/chain
    3 Results
  • Crankshaft/crankcase
    3 Results
  • Carburetor - 530069703
    3 Results
Find part by diagram >

Question and Answers

Q:

Craftsman chainsaw #358.3504.61 - 16 inch bar will not start, when you pull on rope it kicks back. Thank for a troubleshooting guide to examine & repair this.

A:

I'm sorry to hear that you are having some difficulties with your Chain Saw. I did some research for you at Managemylife.com and found expert answers to similar questions that may help until your expert can respond to your specific question. The links are attached below. I hope these links provided assist you.

Read More
Priscilla V -
December 07, 2011
A:

Have you checked the handguard to make sure the chain brake has not been activated? Pull the guard back toward the handle to "reset" it. Then see if the saw is able to be pulled/started. If the problem is still present then there is likely a problem with the clutch.

Let me know what you find with this and we can proceed as necessary.

Thank you for using Manage My Life!

Read More
XX Wade_ -
Sears Technician
December 08, 2011
See more answers
Q:

how do i get chain oiler off

A:

Hello, I can understand how frustrating it could be to fix an appliance. If you go to the top of the page here on ManageMyLife and click on the "manuals" button and enter your model number you will be able to access you manual. I hope this helps!

Read More
Jacqueline S -
June 25, 2010
A:

The clutch will need to be taken off as well as separating and removing the side of the saw in order to access and remove and replace the oiler.

If you do not feel confident repairing this problem yourself, then you can have it repaired by a Sears technician. Here is a link that will provide the nearest drop-off locations: Sears Home Services .

Read More
Joey S -
Sears Technician
June 28, 2010
See more answers
Q:

My chainsaw is not firing. How do I test the module?

A:

You need to remove the kill wire from the module and check the magnets in the flywheel.

Remove the screws that hold the cover with the starter assembly in it and remove the cover. Disconnect the wire that is connected to the ignition module. The wire to the spark plug is soldered to the coil, disconnect the wire that is plugged on a terminal. Test the magnets in the flywheel by placing a screwdriver blade or a wrench against them. If the magnets hold the screwdriver or wrench to them, they are good.

Pull the starter rope and test for a spark without the spark plug attached to the wire. If you have no spark, the ignition module is bad.

Read More
Jimmy K -
Sears Technician
October 30, 2009

Top Parts