Model #358350380 CRAFTSMAN Chainsaw, Gas

  • Flywheel
    3 Results
  • Crankshaft
    3 Results
  • Carburetor #530069703
    3 Results
Find part by diagram >

Question and Answers

Q:

Won't start when hot 358350380 Craftsman Gas chainsaw

Q:

new thermal cutoff switch lasted for four loads and failed, any ideas EGD4400WQ0

A:

Thank you for your inquiry on your Craftsman Chainsaw, Model: 358.350380. From reviewing the details on your model, Make sure that the lint screen is clean. Wash it with water and a nylon brush to remove fabric softener residue that can build up on it. When it is completely dry, replace it in the lint screen housing. Disconnect the flexible vent hose behind the dryer so that it will vent directly into the laundry room. Ventilate the laundry room as much as possible. Position the dryer so that you can measure the temperature of the air coming out of the exhaust vent behind the dryer. Load the dryer with a medium load of towels or garments that can tolerate the high heat setting. Start a timed cycle on the regular high heat setting. Measure the temperature of the air coming out of the vent in the back of the dryer. The dryer should heat up to about 150 degrees and then cycle between 140 and 150 degrees. If the dryer is heating and cycling properly, then a restriction in the exhaust vent to the outside of the sum is likely causing your thermal cut-off fuse to blow. You also could have a high limit thermostat that is stuck closed since it should open at 250 degrees and prevent the thermal cut-off fuse from blowing.

Safety Warning: Before beginning the repair, disconnect the direct power supply to the dryer to prevent the risk of injury or any electrical shock.

If you don’t feel comfortable or confident in this repair, then you can have it repaired at home by a sears technician. I have the included a link to the website: Sears Home Services or call 1-800-469-4663

I hope this answered your question. Thank you for contacting SearsPartsDirect.com, and have yourself a wonderful day. 

Read More
Gerry93 -
Sears Technician
April 02, 2015
Q:

What size file do I need to sharpen this blade. It does not say in the manual. 358350380 Craftsman Gas chainsaw

A:

Thank you for your inquiry on your Craftsman Chainsaw, Model: 358.350380. From reviewing the details on your model, from the information I’m pulling up it appears that you would use a 4mm file to sharpen the chain’s teeth. 

Safety Warning: Before beginning the repair, disconnect the direct power supply to the chainsaw to prevent the risk of injury or any electrical shock. 

If you don’t feel comfortable or confident in this repair, then you can have it repaired at home by a sears technician. I have the included a link to the website: Sears Home Services or call 1-800-469-4663

I hope this answered your question. Thank you for contacting SearsPartsDirect.com, and have yourself a wonderful day. 

Read More
Gerry93 -
Sears Technician
April 02, 2015

Top Parts