Model #358350202 CRAFTSMAN Chainsaw, Gas

  • Cylinder/shield/crankshaft
    3 Results
  • Chain/bar/handle/housing
    3 Results
  • Carburetor - 530071492 (wt-610)
    3 Results
Find part by diagram >

Question and Answers

Q:

dryer repair 358350202

A:

Thank you for choosing SearsPartsDirect. I will be more than happy to assist you with your Kenmore dryer.

From the information you have provided above, upon researching model number 110.8751172. it seems like there is an issue with the main control board. the F01 error code states it can possibly be a main control board power failure. I would suggest to unplug the dryer for about 5-10 minutes and see if the dryer resets, if not you will need to most likely replace the control board.

I hope you found this information useful. Again thank you for choosing Sears, we appreciate your business, have a great day.

Read More
Benny23 -
Sears Technician
February 02, 2015
A:

I tried unplugging it and it still does not work. What part do i need to order and how difficult is it to replace?

Read More
amy -
February 02, 2015
A:

It is going to be the main control board that needs to be replaced. the part number is W10111606. When it comes to the control boards off of any I recommend to have a qualified technician to properly install the part. It can be pretty tricky to properly install.  If you would like to try the repair yourself I have linked some information that shows you what you’re up against. Click here. If you want to have a technician out you can call 1-800-4MY-HOME.

Again thank you for choosing Sears, we appreciate your business, have a great day.

Read More
Benny23 -
Sears Technician
February 02, 2015
See more answers
Q:

oiler over oiling 358350202 Craftsman Chainsaw

A:

Make sure you're using bar and chain oil. Other oils are typically too thin and this can be the result of that. If you are using bar/chain oil and this continues to happen, you can only replace the oil pump. From my experience with these, they are just going to leak oil. I have replaced pumps and then have the problem come back after a few months. I've gotten to where on my own saws, I just leave them sitting on top of a pile of oil absorbent to prevent any messes in the shed. If you store the saw with the bar/sprocket side up then it doesn't usually make much of a mess. I wish there were a solid fix for this, but there isn't much other than to replace the pump.

Thank you for using Manage My Life!

Read More
Wade_B -
Sears Technician
September 30, 2013
Q:

how do I go about finding a chain to purchase for my model of chainsaw?

A:

Finding the right parts the first time and doing it without running around to different stores is the way to go. A good option is to visit Sears Parts Direct and see all the parts available for your chainsaw and ordering right online. I attached the link with your model below. Hope this helps!

Read More
Barbara H. -
October 10, 2010
A:

Thank you for your question.

I have checked the model number you have submitted. The part number for the 20 inch chain is H78. Please click on this link to order the chain from Sears.com

The part number is an Oregon number so you can purchase the chain from any place that sells Oregon chains, if you are not near a sears store.

If you need further assistance, please reply below.

Thank you for using Manage my life. Mark T.

Read More
Mark T -
Sears Technician
October 11, 2010
See more answers

Top Parts