Model #35834140 CRAFTSMAN Chainsaw, Electric

  • Replacement Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Bar & chain oil Leak 35834140 Craftsman Sears chain saw

A:

Thank You for choosing Sears PartsDirect.com. It is unfortunate to hear that you are having issues with your chainsaw and I do understand your frustration. Glad to help out. I'm looking at your model number 35834140 and here is a video that will help with the repair. It is very possible that the oil actuator may need to be replaced. I have included a link to our PartsDirect page where you can purchase the part you need to complete your repair. Just click the blue link above to be taken to the page. If you have further questions please resubmit your question for further information.
 
Thank you for choosing Sears PartsDirect.com. 

Read More
Sherman_G_Wallace -
Sears Technician
July 16, 2014
Q:

Why won't my Craftsman electric chain saw start?

A:

On this particular chain saw it will most likely be one of three things, the power cord, the switch, or the motor. The motor for this model is no longer available. There are no wiring diagrams or illustrated teardown instructions for theses saws either. Service technicians are expected to rely on their knowledge and experience when faced with a situation where no service information is available.

If you have a volt/ohm meter and are comfortable working around live electricity I can give you a few checks that will help you diagnose the problem. Always unplug or de-energize electrical equipment before removing covers or attempting service. Be careful and wear appropriate hand protection when working around sharp metal parts. I would begin by checking the outlet you are using with say a hair dryer known to be in working condition, then if needed check the household breakers. Next with the covers removed and the unit plugged in, check across the two wires leading into the switch. You should have 120 VAC. If not the cord is bad and will need to be replaced or repaired. If you have voltage into the switch, check voltage out of the switch with the switch in the run position. It should be 120 VAC. If not the switch is bad. Other than that, if your motor is bad you will need to replace your chainsaw.

I have included a link that you may use for parts purchases; please click the following Sears Parts Direct

If you require further assistance please resubmit your question with details of the checks you have made. I will be looking forward to helping you again in the near future.

Read More
Landell -
Sears Technician
March 10, 2010
A:

this is NOT an electric saw. it is model # 358.351202 gasolene engine....

Read More
belle springs -
March 22, 2011
See more answers