Model #351224010 CRAFTSMAN Saw Band

  • Stand
    3 Results
  • Band Saw
    3 Results
Find part by diagram >

Question and Answers

Q:

Have Sears band saw, model 351.224010 which takes blade p/n 29465.00. What is the length and width of the blade?

A:

Managemylife.com is always a great resource to find the answers to just about anything especially Sears tools. I know this information can be very helpful for you to have. While you have been waiting for your expert to respond, I did some research but I was unable to locate information that would be helpful with regards to your question at this time. Your expert will be answering you within two business days but usually sooner. Thank you for using Manage My Life. I hope you are online again soon.

Read More
James -
November 12, 2011
A:

The 29465.00 band saw blade is 99 3/4 inches long. The blade included with the band saw is usually 3/8 inch wide. I can not be sure how wide the blade in your band saw is.

You can measure the width of the blade and the teeth per inch.

Read More
Jimmy K -
Sears Technician
November 15, 2011
A:

I would like to order a 3/4 " replacement blade for my ban saw. how and what is a part #

Read More
eddie -
March 17, 2013
A:

I purchase my band saw blades on www.sawblade.com . They custom blades and offer pretty good prices.

Read More
Anonymous -
March 20, 2013
See more answers
Q:

Noisy Bandsaw blade

A:

Good morning.... I can fully understand your confusion over the new blade. I will forward your question to an expert who will investigate the matter further and get back to you. You will hear from them within two business days if not sooner. Until you hear from us, have a nice day.

Read More
Henry -
January 17, 2013
A:

You may try moving the little bearing/guides back away from the blade just a slight amount and see if anything changes. I have a friend that took the bearings off and replaced them with some guide blocks because of the sound it made. If that does not take care of the issue then you may need to have someone come out and physically look at the saw.

Thank you for using Manage My Life!

Read More
Wade_B -
Sears Technician
January 19, 2013
A:

Thank you Wade, that was exactly the issue. My husband figured it out later that day. Apparantly, the new blades teeth were raised enough (because it was new), they were riding on the bearings and creating the loud noise. Thanks so much for taking the time to answer my question. Jackie V.

Read More
Jackie -
January 23, 2013
See more answers

Top Parts