Model #351217581 CRAFTSMAN Planer

  • Base
    3 Results
  • Rollercase
    3 Results
Find part by diagram >

Question and Answers

Q:

What is the lip on the rollercase of my craftsman planer model 351.217581?

A:
Korinna S -
Sears Technician
August 15, 2012
A:

I certainly understand this can be frustrating. I have done some research and located a link that may be helpful until an Expert responds. I hope this helps and thank you for using Manage My Life!

Read More
Carmen G -
August 15, 2012
See more answers
Q:

work doesn't feed properly.

A:

Problems with the feed on a planer can cause wasted materials as well as aggravation. The expert will review this model to respond, but I did locate the owner's manual and attached to the link below. Check page 9 for adjusting the planer table. I hope this information does help.

Read More
Barbara H. -
June 24, 2012
A:

Unfortunately it doesn't help. I have the manual. That page is for adjusting table evenness Though I did take off the cover as suggested from an older model entry and I think it has to do with the springs. The outfield spring very tough, infield much easier to compress.

Read More
sumner -
June 24, 2012
A:

Thank you for the question on the out-feed roller not compressing for the work to pass through.

There is no adjustment for these rollers.

I have seen where the sliding pillow bearing blocks will gum up and will not compress for passing the board through.

I know you said you cleaned the machine but did you clean the pillow blocks with the compression springs on them as they slide in the roller case housing?

Please let me know if cleaning those bearing blocks and the housing they compress into solved the problem.

Sam A.

Read More
Sam A -
Sears Technician
June 27, 2012
See more answers

Top Parts