Model #35 HOOVER Vacuum, Upright

  • Agitator
    3 Results
  • Cleaningtools
    3 Results
  • Handle
    3 Results
  • Hose
    3 Results
  • Mainbody
    3 Results
  • Motor Assembly, Hood
    3 Results
  • Outerbag
    3 Results
Find part by diagram >

Question and Answers

Q:

My vissani beverage cooler quit cooling MCBC58DST Vissani 5.8 liter beverage cooler

A:

Thank you for choosing SearsPartsDirect.com. I will be more than happy to assist you. I can understand any frustration you may have experienced with regards to your unit. Let’s see what we can do for you.

Looking into the information on this Vissani beverage cooler I'm showing the main issue could be the compressor. When these stop working (Not Cooling, I would normally point to the protector, or starter. These are on the side of the compressor and are what allow it to run properly. If you take them off you can shake them if they rattle they might need to be replaced. The part number for this is 312200500113.

Hope this information has helped you. If you are not comfortable doing this repair you can click here to schedule a technician or call toll free 1-800-469-4663. Again, thank you for choosing SearsPartsDirect.com.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
JeffwallaceIII -
Sears Technician
July 03, 2015
A:

I just had this happen with my Vassani beverage cooler. It was indeed the starter device. It's located on the left side of the compressor and pulls off easily. Here's what you do: To get to the compressor, remove the back panel. You then have to remove a cover that is over the starting device (on the left side of the compressor). The cover is held on by a thin metal tension spring. Pull this off and you'll see the starting device with a lead wire attached to it, on the side of the compressor. Pull off the lead wire and you should be able to wiggle the device free. If it rattles, it's broken. I'm not a repair guy but there's a ceramic disk inside the device that's about the size of a quarter that looks like it serves as some sort of conduit limiter between two sets of prongs/contacts. I'm probably all wet but anyway mine was broken and fell out in a bunch of little pieces. Ordered a replacement part from Home Depot for $28.00 plus $6.00 shipping. Put the new one on and it works like a charm....nice and cold.

Read More
Corey -
January 31, 2016
See more answers
Q:

CRAFTSMAN SNOW THROWER PROBLEMS

A:

It is hard to believe there is still so much snow to deal with in the country. I searched and found two other expert posts for your model that may help provide some answers. I attached the links below. Hope this information helps you get back to clearing that snow.

Read More
Barbara H. -
March 13, 2011
A:

THANKS THE LINKS U SUPPLIED WERE VERY HELPFUL, APPRECIATE IT

Read More
william -
March 13, 2011
A:

This could be caused due to the ignition coil failing. I lean that direction because you have to let the machine cool down before it will start back and run correctly. That is almost always going to be a problem with the ignition coil or with the machine not getting fuel. When it begins to run bad, loosen the fuel cap slightly and see if it clears up. If it does not, I would say to replace the ignition coil.

Thank you for using Manage My Life!

Read More
XX Wade_ -
Sears Technician
March 14, 2011
A:

I am having the same problem... during the cool down time, I do still have spark, so it wouldn't be the ignition. I need a breakdown pic of the carburetor. can you help?

Read More
Nuvar -
January 25, 2016
See more answers
Q:

CAn I please have the LInkage sketches 34, 35 , 37 143985012 Craftsman Engine

A:

Thank you for your inquiry on your Craftsman Engine, Model: 143.985012. From reviewing the details on your model, I have provided a link which takes you to the full diagrams for the engine. The link is found below.

Click Here

Safety Warning: Before beginning the repair, disconnect the direct power supply to the engine to prevent the risk of injury or any electrical shock.

If you don’t feel comfortable or confident in this repair, then you can have it repaired at home by a sears technician. I have the included a link to the website: Sears Home Services or call 1-800-469-4663

I hope this answered your question. Thank you for contacting SearsPartsDirect.com, and have yourself a wonderful day. 

Read More
Gerry 93 -
Sears Technician
April 06, 2015
A:

have a problem hooking the carb links and springs back up if you have and diagram in how they all go back together wood be much helpful .

Read More
clark -
September 22, 2015
A:

im having a problem with the likages throttle and govanor linkage please show me a diagram to put them together would be very helpfull thanks.

Read More
samuel -
January 19, 2016
A:

im having a problem with the likages throttle and govanor linkage please show me a diagram to put them together would be very helpfull thanks.

Read More
samuel -
January 19, 2016
See more answers

Top Parts