Model #348A EUREKA Power Steamer

  • Steamer
    3 Results
Find part by diagram >

Question and Answers

Q:

gas range oven temperature? 348A8035P029

A:

Thank you for choosing Sears Parts Direct. The model number is not bringing up any information on this unit. In general it could be the thermostat or the control board. We won’t have much information if the model number provided is correct.

Thank you for choosing Sears. We appreciate your business. Have a great day.    

Read More
Jeff Wallace Jr -
Sears Technician
February 02, 2015
Q:

dead mouse in my stove

A:

I am sorry to hear about this issue that you are having. The ManageMyLife website is a great place to find answers to questions that need qualified and insightful responses. I would suggest that you provide a little more information such as the make and complete model number of your product so your expert will be able to research and provide you the best possible answer. Share any insightful information that could be helpful. Continue this existing thread. Just click on the gray reply box below and provide that information. This will speed up the process for you.

Read More
James -
May 02, 2012
A:

The technical data sheet is: 164D2773P048 The wiring digram is: 348A8005P051 The dwg is: 348A: 80055IRO I cannot find a model #. It is a Kenmore gas stove about 12 years old' I did manage to remove some of the insulation (?) with a skewer and and some tongs. That is definitely where they were residing. An entire nest I believe and that is where the stench is coming from. I'm going to try and remove more later. Should I attempt to remove the back (how?) and should this material be replaced? Thanks in advance

Read More
linda -
May 02, 2012
A:

Thank you for your question and I understand your concern.

The model number is likely at the front somewhere around the oven cavity opening or on the frame behind the broiler drawer or storage drawer.

The insulation covers the oven cavity on the sides, rear and top. In order to access the insulation you will likely need to remove the top, rear panel and possibly the side panels. NOTE: Disconnect the power cord from the power source before servicing.

I was not able to locate a model number but I did find the mini manual and it shows that your range has sealed surface burners. In order to hinge the top open you must first remove the sealed burner caps and the bases. See image below.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
May 03, 2012
See more answers
Q:

Need replaecment filter

A:

Needing to purchase a replacement is great to do when your appliance isn't working properly. While you are waiting on an expert to answer your question, a suggestion I have is to visit Sears Parts Direct website. I have attached the link below. Hope this helps!

Read More
Dezeray S -
April 02, 2011
A:

Thank you for your question.

I am sorry you are having a problem finding the filter for your air conditioner. I have tried to look up you model number and did not have any luck finding that model. I have also looked for 32 x32 filters and could not find any on the internet. Even the cut to fit are not that big. I am not sure what type of set up you have but you might be able to use two 16 x 32 filters, just tape along the center to hold them together.

If you would like to provide more information and a post a picture I will try to further assist you.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
April 02, 2011
See more answers