Model #31H777-0202-E1 BRIGGS & STRATTON Engine

  • Blower Housing/air Cleaner
    3 Results
  • Alternator/motor Starter
    3 Results
  • Cylinder/crankshaft
    3 Results
  • Carburetor
    3 Results
  • Cylinder Head/gasket Set
    3 Results
  • Sump/pump
    3 Results
  • Flywheel
    3 Results
Find part by diagram >

Question and Answers

Q:

where is location of ammeter rectarular 6 apm 917272751 Craftsman Lawn tractor

A:

Thanks for the inquiry and for being a valued member.

Based upon the tractor model, I show the engine as a Briggs with a model of 31H777-0202-E1. The alternator is underneath the flywheel. Will be a round coil held down by 4 screws. The wires from it will go to the regulator. The regulator is part of the engine and will be located on the engine itself. Usually the regulator will be a little square about 1.5inches by 1.5inches and will have 2 wires coming into it from under the flywheel and 1 wire (normally red) coming out of it going to the tractor.

I hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
August 04, 2015
Q:

Fuel Hose? 917272760

A:

Thanks for the inquiry and for being a valued member.

Based upon your description that the hose goes into the engine, it sounds like the breather tube, but it would not have fuel. There are a few different fuel lines listed for this Briggs engine. I am not entirely sure which one you are referring to. There are some molded fuel lines and some that are straight. There are a few shown on the 'Sump/Pump' schematic, and a few shown on the 'Blower Housing/Air Cleaner' schematic. 

The best thing would be to view the schematics to match it up. I have linked them below for convenience.

Briggs 31H777-0202-E1 Schematics

I hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
June 11, 2015
A:

Hi, when it broke fuel was leaking out of it. Can I send you a picture of where it is located. I don't see it on the diagram, but I am not to good at reading them. I know one end tucks into the metal part of the engine on the right side of the engine if you are looking at it.

Read More
Brandon -
June 17, 2015
See more answers
Q:

valve setting. 917272751 Craftsman Lawn tractor

A:

Thanks for the inquiry and for using SearsPartsDirect.com.
For this 31000 series Briggs engine, the head torque value is 220 in. Lbs. The intake valve clearance is .003"-.005" and the exhaust valve clearance is .005"-.007". 
For convenience, I have provided a couple of resources below that may be helpful to you in the future. The first is a Briggs engine torque specification sheet, and the other is Brigg's engine manual for this engine model of 31H777-0202-E1. 

Briggs Engine Torque Specification Sheet

Briggs Owners Manual for Model 31H777-0202-E1

Hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
August 04, 2014
A:

So which is the intake? Top or Bottom?

Read More
Scott -
June 04, 2015
See more answers