Model #31AS2S5D799 MTD Snowthrower, Gas

  • Auger Housing/fuel Tank/wheels
    3 Results
  • Chute/cover/handle
    3 Results
  • Decals
    3 Results
  • Auger/lower Handle/fuel Tank
    3 Results
  • Chute/upper Handle/cover
    3 Results
  • Decals
    3 Results
Find part by diagram >

Question and Answers

Q:

What socket size can I use to remove a 710-0627 ("Hex Lock Screw 5/16-24 x .750")?

A:

An expert shall have an answer to your question shortly. Usually it takes about 24 to 48 hours for a response. Have a nice day.

Read More
Alina F. -
February 03, 2011
A:

Thank you for your question.

I am sorry you are having problems with the snow blower. You need to use a 1/2 wrench or socket to remove the bolt. Once the belt cover is removed and the engine turned off have someone hold the auger lever down while you check the belt tension. If the belt is, loose adjust the belt tension. The instructions for adjusting the belt tension are located in the manual towards the back. I also recommend checking the shear pins. If the pins are sheared, the augers will not turn also.

Please let me know if you need further assistance on this problem.

Here is a link to order any parts you need. Sears Parts Direct .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
February 03, 2011
A:

Mark Appreciate the response. I will check it out and report back. Thanks again! Dan

Read More
Dan -
February 03, 2011
See more answers

Top Parts