Model #31527441 CRAFTSMAN Die grinder

  • Housing
    3 Results
  • Motor Break Down
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

Have to replace Lock Pin part # 611917 in Die Grinder 31527441

A:

I understand your replacing the lock pin to your Die Grinder. I found it easy by going to Sears Parts Direct.com and you can purchase the item online, as long as you have your model number or part number you can find the part there, while your waiting on an expert answer. I attached the link below, I hope this helps!!!!!!!

Read More
Raquel F -
August 23, 2010
A:

Thank you for your question.

  • To replace the lock pin on your Die grinder you will need to remove the collet nut and the collet. Then remove the 4 screws that secure the drive shaft housing to the motor assembly.

• Now carefully slide the front housing off the drive shaft. With the drive shaft removed, locate the retainer clip on the inside top of the front housing, then remove the old pin and re-install the new pin and retaining clip. Re-install all components in correct order.

• The part number for the lock pin is: 611917-003 and you can order this from:Sears Parts Direct .

• I have included the parts page below.

  • I hope this helps.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
August 24, 2010
See more answers

Top Parts