Model #31511760 CRAFTSMAN Sander

  • Unit Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Why does the belt on my 4" Craftsman commercial belt sander keep pulling to one side?

A:

The belt is tracking off center because it needs a slight tracking adjustment. See image below. There will be a knob or screw to rotate located on the back side near the yoke and slide assembly (key#19&11) that will cause the yoke/slide assembly to pivot left or right. You will need to make the adjustment in small increments while watching the belt. NOTE: This procedure in normally performed while the unit is running, so use CAUTION.

Read More
Joey S -
Sears Technician
October 08, 2009

Top Parts