Model #315114520 CRAFTSMAN Drill Driver

  • Housing And Motor
    3 Results
  • Chuck/battery Pack/charger
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers


Craftman 12.0 Volt Ex Charger 315.114520 Craftsman Drill-driver


Thanks for the inquiry and for using

Sears recommends to stay with the original parts for the drill. A 14.4 volt will not be compatible with the 12 volt drill you have. The original charger is still available for the drill, which is what we are recommending.

For convenience, I have included blue links below that you may click on to be directed to the PartsDirect page to view and purchase the charger and a replacement battery if you need one.

Charger for Model 315.114520

Battery for Model 315.114520

Let us know if we can be of any further assistance and thanks for using 


Read More
Jeff Wallace Sr -
Sears Technician
December 03, 2013

What causes two individual batteries to beep after four minutes then go dead?


The batteries might be bad. Try putting the batteries in the drill and put a piece of string or tape around the trigger so it is held on. You want to drain any power that is left in the batteries. Leave them in the drill after they stop driving the drill for 5-10 minutes.

If you can't charge them after this they are bad.

These batteries are bad about retaining a memory of short charges then that is all they will take. You should always run the batteries all the way down then recharge completely. Any short charges will shorten the life of the battery.

Read More
Jimmy K -
Sears Technician
May 23, 2008

Top Parts

  • Screw

    Part: 616478-003

    $ 3.99

    In Stock