Model #311707-0125-E1 BRIGGS & STRATTON Engine

  • Cylinder Assembly
    3 Results
  • Carburetor
    3 Results
  • Motor-starter
    3 Results
  • Short Block
    3 Results
  • Schematic
    3 Results
Find part by diagram >

Question and Answers

Q:

does this model 917.271741 have a clutch safety switch 311707-0125-E1 Briggs&stratton Engine

Q:

ignition 311707-0125-E1 Briggs&stratton Engine

A:

Thanks for your question- we see that no one from the community responded.  If you still require assistance on this topic, please resubmit your question with any updated information and we will have one of our experts take a look.  Also, we have updated our site to include information regarding common repairs and diagnosis, which can be found here: www.searspartsdirect.com/repair-help.html.  If you are looking for your owner’s manual, it can be found here: http://www.searspartsdirect.com/partsdirect/user-manuals.  Thanks for visiting SearsPartsDirect.com.

Read More
Sherman_G_Wallace -
Sears Technician
May 14, 2014
Q:

Carborator 311707-0125-E1 Briggs&stratton Engine

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Yadira B -
August 01, 2013
A:

you would need to remove the carb bowl and the float and the needle valve for a good cleaning that may do it and check the float to make sure there is no gas inside the float. usually the seat and needle valve get dirty and won't stop the flow of fuel when the bowl is full. you can clean the seat by spraying some carb cleaner into the seat.

Read More
TC -
August 01, 2013
A:

Thank you for using ManageMyLife.com. I am sorry to hear of the carburetor flooding issue you are experiencing, I know how frustrating that can be, especially since the grass doesn't wait to grow while you are down and out.

You hit it on the head, its definitely a carburetor issue, more specifically, the float and/or needle and seat. The seat could be sticking and causing the float not to operate properly. You may not have to replace the float, but I would recommend to replace the needle and seat if it hasn't been done lately. At the very least, take the carb apart and spray some carb cleaner around the seat area to make sure there are no old fuel deposits build up there causing the problem.

For convenience, I have included the discussed parts below for this carburetor/engine. Just click the blue link to be directed to the PartsDirect page to view and purchase the part.

Note: If you decide to purchase a rebuild kit for the carburetor, there is a difference in kits between the brand of carburetor you currently have. We offer rebuild kits for Nikki and Walbro on the parts list, so verify which carb you have if you decide to purchase a rebuild kit.

Needle Float Valve for model 311707-0125-E1

Inlet Seat for model 311707-0125-E1

Float for model 311707-0125-E1

If you have any further questions or inquiries, please don't hesitate to ask. Thank you for using ManageMyLife.com.

Read More
Jeff Wallace Sr -
Sears Technician
August 01, 2013
See more answers