Model #3104 BLACK & DECKER Saw Reciprocating

  • Unit Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Kenmore Elite Gas Range Slide-in Model #790.31043800 I have a default on the Gas Range model number above, the default number is 5A6.

A:

I understand that your Kenmore Elite gas range has an error code displayed. While you are waiting for an expert to respond, I have attached some helpful links below that may provide information to assist you with your question. Have a great day!

Read More
Alina F. -
April 21, 2012
A:

Thank you for your question and I understand your concern.

The fault code "5A6" is not one of the fault codes listed. It may appear as a "5A6" but I have never heard or seen this code before.

Based on the failure I suspect a faulty electronic oven control or possibly a faulty touch panel and I strongly suggest calling a service technician to properly diagnose and repair your range. Since the fault code displayed on your range is not on the list I can be certain or which component has failed. This is why I strongly suggest calling a service technician to diagnose the failure.

I added list of the fault codes below in the image. You will see that there is no "5A6" fault codes listed.

If you feel confident in removing and replacing the electronic oven control/clock assembly; I added an image below with the procedure. NOTE: Disconnect the power supply from the range before servicing.

The electronic oven control #316577019 for Kenmore range model 790.31043800 can be ordered from Sears Parts Direct.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
April 24, 2012
A:

the 5a6 is a sab thats setting for the jewish sabbath look in the manual it tells you how to shut it off

Read More
sam -
December 29, 2015
A:

the 5a6 is a sab thats setting for the jewish sabbath look in the manual it tells you how to shut it off

Read More
sam -
December 29, 2015
A:

is there a recall on those controllers mine died a slow death first parts of the numbers didn't lite. mainly in the clock section then the heat number started acting up . this is not a cheap oven it started acting up after about 2 years. And i see allot of the same clock don't complaints

Read More
sam -
December 29, 2015
See more answers
Q:

CANNOT FIGURE HOW TO REMOVE STOVE STORAGE DRAWER

A:

There is nothing more annoying than trying to remove a stubborn part. The experts here on Manage My Life will be able to assist you. It usually takes 24-48 hours to receive a response. Have a great day!

Read More
Jackie S -
July 25, 2011
A:

Thank you for your question and I understand your concern.

According to the model number provided it should release as follows. I also added an image below taken from the Owner's manual.

Getting the drawer to release can be tricky. You will need to slide the drawer open completely and pull the lever up with your finger on the left glide and push down on the lever with your finger on the right glide and slide it out of the glides.

Read More
Joey S -
Sears Technician
July 26, 2011
A:

Your image from the manual is so small that it is totally useless. Can't you provide one that is visible to people using a 15" laptop?

Read More
Ken -
August 20, 2013
A:

Ken: Without knowing the model number of your range, I will assume the model is 790.3103xxxx or 790.3104xxxx. Copy and paste the URL below in your browser to view the Owner's Manual. It will have the instructions for removing the warmer drawer. http://www.managemylife.com/mmh/lis_pdf/OWNM/L0809212.pdf

Read More
Joey S -
Sears Technician
August 21, 2013
See more answers
Q:

410A freon for room A/C

A:

I think its great that you are wanting to do some repairs on your own and I will be happy to help. I did some research and I was able to find a link that will provide you with some good information. I hope this helps with your repairs while you wait for your expert response.

Read More
Joseph P. -
September 13, 2012
A:

thank you! I am a master A/C repairman. i haev a unit with a data platr that is unreadable. I just need to knor how much freon it holds . the compressor is 410 A it is only abour a year old so I know it is not R22

Read More
milton -
September 13, 2012
A:

Thank you for your question. This model holds 31.04 ounces. I hope this will help you. Thank you for using Manage My Life.

Read More
Scott D -
Sears Technician
September 14, 2012
See more answers

Top Parts