Model #3060 BLACK & DECKER Saw Circular

  • Unit Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Why does my mower keep stalling out? 917.370411

A:

Thanks for the inquiry and for being a valued member.

It sounds like you've got an internal carburetor blockage. A thorough carburetor cleaning should solve the issue.  

I would pull the carb from the engine. With a full can of carb cleaner, a wire brush, and a bread tie wire to poke through and clean the main jet; I would recommend a very thorough cleaning. Start by taking off the float bowl. Douse it very liberally with carb cleaner, and undo the pin for the float, and remove the needle and float. Clean them very thoroughly with the wire brush and carb cleaner. Pay close attention to the seat the needle sits in and clean it well. Once clean, start brushing the carb bowl and body and make sure you get all the varnish out. It may take three or four brushings with carb cleaner dousing in-between. From there, take the straw of the carb cleaner and shoot carb cleaner through any little hole or passageway of the carb. Shoot out the throat of the carb and poke the main jet with the bread tie wire. You have to make sure you get everything the first time, if you leave anything behind, it’s likely to reclog once you have it reassembled. 

I hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business.  

Read More
Jeff Wallace Sr -
Sears Technician
July 13, 2015
Q:

We have a model 316.711930 Craftsman Weedwacker. Very hard starting. 316711930 Craftsman Trimmer

A:

Thanks for the inquiry and for being a valued member.

I am sorry to hear of the intermittent starting issue you're having with the trimmer. I know how frustrating that is to have happen.

When starting the trimmer cold, just make sure you're not giving it any throttle after priming an while pulling the start rope. Doing so may cause the engine to flood, and prevent it from starting. After priming and pulling the rope, allow 30-60 seconds for the engine to warm up before giving it any throttle. 

If you are already following those procedures and that is not the issue, you likely have a restriction within the carburetor, and you will either need to pull and clean the carburetor, or replace it. With it starting periodically, compression and spark should be good. 

I hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
April 03, 2015
Q:

trying to trouble shoot an amana fridge not cooling model # 59672254200 59672254200

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your refrigerator. Upon researching model 59672254200; its sounds like you may need to replace the capacitor. The capacitor allows the compressor to properly start, so when it fails the compressor will click on and off trying to start but will keep turning off. The compressor will normally get hot when it clicks on and off due to a capacitor failure, I have posted a link of the capacitor to view the link click here.

I trust this information will help you, we appreciate your business thank for choosing Sears.

                          

Read More
CarlosZ -
Sears Technician
March 10, 2015

Top Parts