Model #2800 POULAN Chainsaw, Gas

  • Crankcase
    3 Results
  • Main Frame
    3 Results
  • Chain And Guide Bar
    3 Results
  • Carburetor Assembly - #530-035201 Hda - #49
    3 Results
  • Service Reference
    3 Results
Find part by diagram >

Question and Answers

Q:

My vissani beverage cooler quit cooling MCBC58DST Vissani 5.8 liter beverage cooler

A:

Thank you for choosing SearsPartsDirect.com. I will be more than happy to assist you. I can understand any frustration you may have experienced with regards to your unit. Let’s see what we can do for you.

Looking into the information on this Vissani beverage cooler I'm showing the main issue could be the compressor. When these stop working (Not Cooling, I would normally point to the protector, or starter. These are on the side of the compressor and are what allow it to run properly. If you take them off you can shake them if they rattle they might need to be replaced. The part number for this is 312200500113.

Hope this information has helped you. If you are not comfortable doing this repair you can click here to schedule a technician or call toll free 1-800-469-4663. Again, thank you for choosing SearsPartsDirect.com.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
JeffwallaceIII -
Sears Technician
July 03, 2015
A:

I just had this happen with my Vassani beverage cooler. It was indeed the starter device. It's located on the left side of the compressor and pulls off easily. Here's what you do: To get to the compressor, remove the back panel. You then have to remove a cover that is over the starting device (on the left side of the compressor). The cover is held on by a thin metal tension spring. Pull this off and you'll see the starting device with a lead wire attached to it, on the side of the compressor. Pull off the lead wire and you should be able to wiggle the device free. If it rattles, it's broken. I'm not a repair guy but there's a ceramic disk inside the device that's about the size of a quarter that looks like it serves as some sort of conduit limiter between two sets of prongs/contacts. I'm probably all wet but anyway mine was broken and fell out in a bunch of little pieces. Ordered a replacement part from Home Depot for $28.00 plus $6.00 shipping. Put the new one on and it works like a charm....nice and cold.

Read More
Corey -
January 31, 2016
See more answers
Q:

Tub bounces around on spin. hits the cabinet. GLWN2800D0WS Ge Washer

Q:

Kenmore 2800

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your washer. In order to further assist you we will need the model number of the washer. The model number is normally located on the door frame on front load units and under the lid near the rim of the washer  on top load units.

I trust this information will help you, we appreciate your business thank for choosing Sears.

Read More
CarlosZ -
Sears Technician
August 03, 2015
A:

Where can I get a parts diagram for a top loading washer kenmore 2800?

Read More
Jon -
August 03, 2015
See more answers