Model #2783138815 KENMORE Wall Oven, Gas

  • Control Panel
    3 Results
  • Body Section
    3 Results
  • Burner Section
    3 Results
  • Wire Harnesses And Components
    3 Results
  • Oven Door Section
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Installation instructions for Kenmore oven glass needed

A:

I can understand your concern on wanting to obtain instructions to properly replace the glass on your wall oven. I did some research and provided a link to a similar question and answer on our site. I hope this will give you a better idea on the next step to take until the Expert responds to your question in more detail within 24 to 48 hours.

Read More
Julio -
September 10, 2012
A:

I don't have written instructions for that procedure. To complete that repair, you will need to use the parts diagram that his shown in the image below. You will also need to rely on your personal observation of the components. Here are some basic tips that may help:

  1. Remove the door from the range and place it on a padded surface.
  2. It appears that you can remove that inner panel (Key 1) by taking out screws along the perimeter of the door frame.
  3. You should then be able to remove the inner components and access the screws (Key 24) that secure that handle to the door.
  4. There may be other fasteners or components that will need to be removed in order to take out that front glass.

Once you remove that glass you can then replace it and reassemble the door. Make sure that you put the door back together properly.

I hope that this information helps.

If you get to the point where you need to have a service technician replace that glass, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
September 12, 2012
See more answers
Q:

F1 error code appearing on the display of my Kenmore Wall Oven.

A:

Error codes can be confusing for the average non technical person. While you wait for the expert to review your specific model, you can check a previous expert post for this problem. I attached the link below. If you do need parts, a convenient site to order is Sears Parts Direct. I linked it to your model number and added below. Hope this helps start you toward a resolution.

Read More
Barbara H. -
December 27, 2010
A:

From what you're describing it sounds like the ERC has failed. I am sending you a link that explains the error code & recommendations for the repair. Please click on the link below.

The oven will need to slide out to remove the top panel for access to the ERC.

Remember to disconnect power to the oven before attempting access.

What does the F1 error code mean on my Kenmore wall oven?

Read More
biker dave -
Sears Technician
December 28, 2010
A:

Looks like I'll be calling Sears for a techie to come out and help me. Thanks Biker Dave!

Read More
Susan -
April 11, 2011
See more answers
Q:

What would cause my wall oven to ignite for a few seconds and then the ignitor goes off and won't come back on?

A:

Your range has an oven control board and relay board. The failure could be a loose connection between the oven control board and the relay board. It could also be a bad oven ignitor that opens once it gets hot too.

The oven control board supplies 24vdc to the bake or broil relays on the relay board in order to close the relay and cause the oven ignitor to glow.

I recommend calling a service technician to diagnose and repair your wall oven.

Read More
Joey S -
Sears Technician
April 01, 2009

Recommended maintenance parts & accessories