Model #25C4 MAGNAVOX Misc Television

  • No Image Available - Fidelitone
    3 Results
Find part by diagram >

Question and Answers


items freezing GSC25C4EYB00 Whirlpool Refrigerator


Ice maker wont dispence ice GSC25C4EYB02 Whirlpool Refrigerator


Thank you for choosing and being a valued member.  I can certainly understand how frustrating it can be when your icemaker will not dispense ice. 

Remove the front cover of the ice maker to expose the test points on the module. These test points can be 
used to test components and to initiate an ice harvest cycle: 
Check between test points L and N with a Voltmeter set to the appropriate AC scale and confirm the 
presence of 120 VAC to the ice maker. (If source voltage is present and the ice has reached harvest 
temperature the ice maker should cycle).
Initiating a Test Cycle 
? If the ice maker fails to initialize a harvest, a jumper wire (made from a short piece of 14 gauge 
electrical wire that has been stripped back ½ inch on both ends) can be used to start the cycle. 
? Insert the jumper between contacts T and H. This will simulate the closing of the thermostat and will 
energize the timer motor and the heater. 
? Remove the jumper after 5 seconds. 
? The ice maker should continue to run without the jumper in place. 
Note: If the jumper is not removed prior to the ejector blades reaching the 10:00 o’clock position, the water 
valve will not energize. 
If ice maker starts, go to step 7 
If ice maker fails to start: 
? If 120VAC is present, replace ice maker module or ice maker.
? If no voltage, check electrical connection coming from freezer door behind the front grille. Remove 
grille and check connection. 
? If connection is good, check for 120VAC at main control board between P1-1 and P3-3. Check specific 
model wiring diagram for specific points. 
? If no voltage is present, replace the main control board. 
Note: After 20 minutes, UI control will automatically exit diagnostic mode. Ensure in diagnostic mode and 
step 25 when checking. 
Step 7: Harvest cycle starts: 
Step 7a: Check for heat at bottom of mold. 
? If there is no heat, replace ice maker. This can also been seen if the ejector stalls on the ice cubes and 
does not push the ice out of the mold within 5 minutes. 
? If heat is present, observe ice harvest. Check to see if any ice cubes jam. 
? If ice cube jams or ice cubes are larger at one end of the mold to the other. Level the ice maker.

You can also visit for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day. 

Read More
Natasha12 -
Sears Technician
October 24, 2014

shoutdown unit model gsc25c4eyy03 Whirlpool Refrigerator


Thanks for your question- we see that no one from the community responded.  If you still require assistance on this topic, please resubmit your question with any updated information and we will have one of our experts take a look.  Also, we have updated our site to include information regarding common repairs and diagnosis, which can be found here:  If you are looking for your owner’s manual, it can be found here:  Thanks for visiting

Read More
Sherman_G_Wallace -
Sears Technician
May 14, 2014

Top Accessories