Model #2536481440G KENMORE Top-Mount Refrigerator

  • Door
    3 Results
  • Cabinet
    3 Results
  • Shelves
    3 Results
  • System
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Icemaker leak

A:

I'm sorry to hear that you are having some difficulties with your Kenmore Ice Biox. I did some research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices.com. I hope these links provided assist you.

Read More
James -
October 05, 2011
A:

Thank you for your question. I can understand your concern about this water leak. The model number listed is not showing to be a valid model. I can only get information on a model 253.6481440G, which may be the same as yours. It does not show to have a water line already installed. You did not indicate what icemaker kit you received. The kit for most all of these units will be # IM115. It will come with all the necessary parts and instructions. There should also only be one location on the back of the unit for the water line to fit through. If you would like more assistance, reply to this thread and please recheck to verify the model number and I will be glad to assist you further. If you can send a picture of the back of the refrigerator cabinet, it will also help. Thank you for using Manage My Life.

Read More
Scott D -
Sears Technician
October 06, 2011
See more answers
Q:

How to install Icemaker Kit IM34?

A:

There should be a hard plastic water inlet tube (see picture) that mounts into the back wall and should make a tight fit (second picture). If this tube was not included in the kit I suggest getting Icemaker Kit IM115. This is another icemaker kit that should work for this model.

If all you received in the IM34 kit is some soft plastic tubing (it may not include the hard tube), it will have to fit through the back wall, all the way to the icemaker fill cup. The plug in the wall will have to hold it snug in place and you will need to make sure it's sealed good, in the back wall. Normally permagum # 4318168 is used for this. In this case I recommend using icemaker kit IM115.

Read More
Scott D -
Sears Technician
September 03, 2009
Q:

Did I get the wrong icemaker kit?

A:

The icemaker kit you need for this model is # IM34. This kit is available at Sears PartsDirect . The water line connections could be the same as the one you have. I'm sending you some information for this type of connection. If you need more assistance, you can resubmit your question with more details.

Read More
Scott D -
Sears Technician
August 19, 2009

Top Parts