Model #25360892408 KENMORE Top-Mount Refrigerator

  • Door
    3 Results
  • Cabinet
    3 Results
  • Shelves
    3 Results
  • System
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

What size is my refrigerator model # 253.60892408?

A:

I can understand how important this information is, especially when you want to buy a new one. While you are waiting for your expert answer, I have found a link to the owner's manual for the refrigerator. I was able to find that this is 18.2 cubic feet. I would suggest that if you are looking for a new one, that you measure the outside of the unit to make sure it will fit in the space. You will need to remember that the refrigerator will need a 1" clearence from the walls. I hope this will help you.

Read More
aashe -
June 06, 2011
A:

The refrigerator model 253.60892408 is 18 cubic feet.

Read More
Kay W. -personal Solutions manager -
Sears Technician
June 07, 2011
See more answers
Q:

Why does ice keep building-up in the freezer control air vent to the refrigerator?

A:

Frost will form from air leaks or a door left open. Also, a large amount of frost may form from heavy use in a high humidity environment. During heavy use in a high humidity environment, moisture will condense on the evaporator cover before the fan can pull it all back to the evaporator. When the refrigerator goes through the defrost cycle, the direct contact will allow the cover temperature to rise high enough to turn the frost to ice. By adding an insulation pad, part number 5316651102, between the evaporator and the evaporator cover (see pictures), it will stop a lot off the heat transfer from the evaporator to the cover during defrost and stop the frost build-up. To install the insulation, remove the back panel in the freezer and cut the insulation to fit from the top of the panel down to the top of the louvers in the evaporator cover. Disconnect power to the unit first. NOTE: Do not block the louvers in the bottom of the cover. Tape the insulation to the back of the evaporator cover and reinstall the cover over the evaporator. The insulation is available at SearsPartsDierct . If you need more assistance, you can resubmit your question with more details.

Read More
Scott D -
Sears Technician
November 16, 2009

Top Parts