Model #25358685895 KENMORE Side-by-Side Refrigerator

  • Freezer Door
    3 Results
  • Refrigerator Door
    3 Results
  • Cabinet
    3 Results
  • Shelves
    3 Results
  • Controls
    3 Results
  • System
    3 Results
  • Dispenser
    3 Results
  • Ice Container
    3 Results
  • Icemaker
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Kenmore water dispenser drips

A:

Water drips can run up a water bill quickly and it would be a major annoyance. I did some research and located two similar questions that may help while you wait for the expert to review this model. I attached the links below. I hope this helps.

Read More
Barbara H. -
February 12, 2012
A:

Thank you for your question. I understand your concern about the dispenser dripping. The information you have received from Barbara on the first link is very good. If this is a constant drip, the water valve # 218832401 will need to be replaced. It's available at SearsPartsDirect . I hope this will help you. If you would like more assistance, reply to this thread and I will be glad to assist you further.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Scott D -
Sears Technician
February 14, 2012
See more answers
Q:

Icemaker model # 5303918277 Fridge model # 253.58685895 Fills then drips, why?

A:

Now that summer is here its time to get this ice maker working right away. While you are waiting on an expert to answer your question, I notice your model numbers you have provided seem to be in correct. A suggestion I have is to verified your model number and attach it to this thread. I also found some great links that can help you for now in the Manage My Life website on ice maker. Hope this helps!

Read More
Dezeray S -
July 19, 2011
A:

The ice-maker model number is straight from the parts list for that model refrigerator. The Fridge model number is from the parts manual that can with the fridge.

Read More
Steve -
July 19, 2011
A:

Water dripping from this icemaker can be caused by the following:

  • Splashing while it's filling
  • Overfilling
  • A leak in the mold

If the icemaker has icicles, this would indicate the icemaker mold has a leak and will need to be replaced.

  • Remove the ice bucket.
  • Loosen the two screws located on the left side of the ice maker securing it to the side of the freezer wall.
  • Remove the one screw below the ice maker securing it to the side of the freezer wall.
  • Raise the ice maker up a pull it over the top two screws.
  • Disconnect the wire harness where it connects to the rear panel.
  • Remove the ice maker and reverse the procedure to install the new ice maker.
Always unplug electrical appliances when removing the covers, or attempting service. Be careful, and always wear gloves when working around sharp metal parts .

I provided a procedure in the image below that shows how to replace the ice maker. That image has poor quality but you should be able to see it well enough to use it for general information. If you do not feel comfortable in completing this repair, service can be scheduled at the following link; Sears Home Services . All parts can be purchased at Sears PartsDirect . The icemaker should come with a set of instructions like the one shown in the first image. I hope this helps.

Read More
Korinna S -
Sears Technician
July 20, 2011
See more answers
Q:

Why is there water, approx 4oz per day in the bottom of the freezer?

A:

There should be no water inside the freezer. If water is freezing on the freezer floor, it indicates the drain is stopped up (frozen). There is a drain pan under the unit, the compressor is mounted on top of it. It's # 22 in the picture. Normally there is a drain tube that can be checked but in some models, the drain is straight down and a tube is not needed. If this is the case, to access the drain, the back panel in the freezer will need to be removed. With the panel off, the trough or drain pan under the evaporator will be accessible. It will probably be full of ice, that will need to be removed and then the drain hole, can also be cleaned out. A technician may be needed to check this.

Read More
Scott D -
Sears Technician
April 24, 2009

Top Parts