Model #25356292409 KENMORE Side-by-Side Refrigerator

  • Freezer Door
    3 Results
  • Refrigerator Door
    3 Results
  • Cabinet
    3 Results
  • Shelves
    3 Results
  • Controls
    3 Results
  • System
    3 Results
  • Ice & Water Dispenser
    3 Results
  • Ice Container
    3 Results
  • Ice Maker
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

My Kenmore refrigerator model #25356292409 is leaking water into the freezer cabinet.

A:

I can understand how this would be important information to have. Managemylife.com is always a great resource to find the answers to just about anything. I was not able to find a solution to your question, but your expert will research your question and respond within two business days but usually sooner. Thank you for using Manage My Life.

Read More
aashe -
January 16, 2012
A:

Thank you for your question. I understand your concern about this water leak. Yes, there will be a flange under the drain trough. However, the trough should not need to be removed. Water will leak into the freezer when the drain system freezes up. Every time the unit goes into a defrost cycle, water will run down into the bottom of the freezer, instead of down the drain. To clear the drain, remove everything in the freezer, so the back panel can be removed. First disconnect power to the unit. With the panel removed, you will see the evaporator coil and directly under the coil is the drain trough (pan). However, it appears you have already gained access to the drain trough. The trough will probably be full of ice that will need to be removed. A hair dryer works well for this. Just be careful not to get it too hot. With the ice out of the trough, you will be able to see the drain hole, which will be plugged with ice. Use hot water to clear the drain hole. Keep working the hot water into the hole and wiping the excess water. This can take quite awhile, depending on how deep the ice is. This will need to be done until you get a good water flow down to the bottom drain pan. With the drain system clear, water should stop leaking in the refrigerator. If you do remove the drain trough, you will need to run a bead of silicone around the bottom flange and then place the trough down on top of it, to make a tight seal. If you would like more assistance, reply to this thread and I will be glad to assist you further.

Read More
Scott D -
Sears Technician
January 18, 2012
See more answers

Top Parts