Model #2535462940B KENMORE Side-by-Side Refrigerator

  • Freezer Door
    3 Results
  • Refrigerator Door
    3 Results
  • Cabinet
    3 Results
  • Shelves
    3 Results
  • Controls
    3 Results
  • System
    3 Results
  • Ice & Water Dispenser
    3 Results
  • Ice Container
    3 Results
  • Ice Maker
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

I purchased this part. The replacement does NOT fit. The water lines to this valve do not push in but screw onto valve.What do I do? 2535462940B Kenmore Refrigerator

A:

Thank you for choosing Sears Parts Direct. I will be happy to help with your refrigerator. Upon researching model 2535462940B; the existing hoses on your unit push into the compression fitting on the valve. You will need to make sure the lines are cut flat, if not you may need to cut them were the screw on nuts were located before. This is the new system that is being used on your model.

 

I trust this information will help you, Thank you for choosing Sears.

Read More
Jeff Wallace Jr -
Sears Technician
December 02, 2014
Q:

How to install the water actuator lever?

A:

First disconnect power to the unit. Remove the drip tray in the dispenser. It pulls straight out. With the tray out, now remove the 3 screws at the bottom. You can now pull out on the cover and lift it up, to free the top tabs. Carefully swing it to the side and unplug the ribbon connector. I'm sending you pictures with instructions now, to access the actuator and replace it. I hope this helps you.

Read More
Scott D -
Sears Technician
September 24, 2009
A:

I need instructions to install replacement ice dispenser lever on model # 253.5462940B please, the part has a # on it also, ABS 302495

Read More
Marty -
September 08, 2011
A:

Is this the actual part you push the glass against in front of the door to get ice or water? I have same model but the ice chute is now "floppy", like a tension coil or similar broke. How to fix please?

Read More
S -
March 05, 2014
A:

Is this the actual part you push the glass against in front of the door to get ice or water? I have same model but the ice chute is now "floppy", like a tension coil or similar broke. How to fix please?

Read More
S -
March 05, 2014
See more answers
Q:

Kenmore 253.5462940B water line freezing and not dispensing water. I have turned down the temperature of the freezer to minimal and line is still freezing.

A:

Manage My Life is a great website to speak directly to an expert who can help you every step of the way to solving the problem you are having. An expert shall have an answer to your question within 24 to 48 hours. Have a great day.

Read More
Alina F. -
September 24, 2011
A:

Thank you for your question. I'm sorry you are having this problem. It does sound like the water line in the door is freezing. Check the temperature inside the freezer, if it gets excessively cold (below zero degrees), this can happen. To check the temperature, place a thermometer between some packages. Air temperature is not a good check. If it is too cold and the thermostat has already been adjusted to the warmest setting, the thermostat # 5304421067 will need to be replaced. If the temperature is ok (between 0 & 5 degrees), it will indicate a void in the door insulation. In this case, the door # 241668152 would need to be replaced. If you would like more assistance, reply to this thread and I will be glad to assist you further.

Read More
Scott D -
Sears Technician
September 26, 2011
A:

Temp is sitting at 5 degrees inside between items in the freezer. Is there a water line heater kit or anything else that can be put into this model. Since this is a design flaw on this particular one why would I have to buy a whole new door because of the workmanship on the door in the first place.

Read More
Bart -
September 26, 2011
A:

Unfortunately, if the temperature is 5 degrees and the line is still freezing, it will indicate a void in the door insulation and there is no heater kit for this. I'm sorry this has occurred, it's not a design flaw, the insulation has just developed a void. Before purchasing a new door, I would recommend having a technician come out to check and verify it. You can call 1-800-469-4663 to schedule a tech to come out. If you would like more assistance, I will be glad to assist you further.

Read More
Scott D -
Sears Technician
September 27, 2011
See more answers

Top Parts