Model #25354624408 KENMORE Side-by-Side Refrigerator

  • Freezer Door
    3 Results
  • Refrigerator Door
    3 Results
  • Cabinet
    3 Results
  • Shelves
    3 Results
  • Controls
    3 Results
  • System
    3 Results
  • Ice & Water Dispenser
    3 Results
  • Ice Container
    3 Results
  • Ice Maker
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Bad tasting water from refrigerator

A:

Thank you for choosing ManageMyLife.com and allowing us to help you. It is always an inconvenience when we experience an issue with a major appliance like a refrigerator's water dispenser. I will do my best to help out. Since you have already changed the filter, you should run about 3 gallons of water through the system to purge the lines and the new filter of filter particles? We have found that if you do not use the water dispenser often, the water that stays in the line for a few days, will pick up the odors and concentrated minerals deposits that may be in the water and will give off that taste and smell. The water quality in your area will also have an effect on the taste and smell of the water as is sits in the plastic tubing of the dispenser. I will suggest that you continue to run at least two to three gallons of water or more a day through the dispenser until it purges out any build it in the lines. I will recommend changing the plastic flexible water line there now, to copper. The interior lines inside will be plastic. It would also be a good idea to replace the water reservoir if this issue continues because it can absorb odors too.

Click here to view some excellent mechanical drawings of your refrigerator. You will find these drawings useful. The reservoir can be purchased there if required. I would hold of on that replacement. It may not be necessary but would be the next step if the problem is not resolved.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others. Wear appropriate hand protection when working around sharp metal parts.

If you do not feel comfortable repairing this problem yourself, you can have it repaired at your home by a Sears technician. Click here to schedule service at the Sears Home Services website. A 10% discount coupon is available when service is set online.

If you have any follow-up questions, please continue our conversation on this existing thread.

Thanks again for choosing ManageMyLife.com

Read More
James -
Sears Technician
October 12, 2013
A:

Thank you for your input! Unfortunately I was not able, using the mechanical drawings, to locate the water reservoir in my refrigerator. Would you please provide the detailed info to how to locate it? Thank you

Read More
Adis -
October 14, 2013
A:

Adis, Thanks for contacting us again. That part is called the water tank at the SearsPatsDirect.com website. The part number is 240545302. Click here to view the parts so you can buy it.

 If you have any follow-up questions, please continue our conversation on this existing thread.

 

Thanks again for choosing ManageMyLife.com

 

Read More
James -
Sears Technician
October 16, 2013
See more answers
Q:

Our icemaker will not draw water into it.

A:

Having ice in our drinks makes our drinks that much better. While you are waiting on an expert to answer your question, I found a great link in the Manage My Life website on your problem. I have attached the link below. Hope this helps!

Read More
Dezeray -
September 26, 2012
A:

I have my manual. It does not show how to reset. Trying to decide if relay switch burned out and needs replacing. Thanks for the help though, Dezeray.

Read More
Jim -
September 26, 2012
A:

I can understand how important it is to have your ice maker working correctly. There are 3 main reasons for an icemaker to stop working:

1.Temperature gets too warm (above 10 degrees) 2.The icemaker itself 3.The water valve

The freezer temperature should be between 0 - 5 degrees. To check the temperature, place a thermometer between some packages, air temperature is not a good check. If the temperature is ok, the icemaker will need to be checked. To see if this icemaker will cycle, pull the front cover off and you will see 2 gears (see picture). Turn the small gear counterclockwise and the icemaker should start into a cycle. If it won't cycle, the icemaker will need to be replaced. If it does cycle, toward the end of the cycle it should fill with water. If it does not fill but you can hear a humming noise, the water valve will need to be replaced. If nothing happens some voltage checks will need to be made. A technician may be needed to make these checks. I'm adding a site you can check to have a technician out. If you would like to schedule service, just click on this link: Sears Home Services . I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
September 26, 2012
See more answers
Q:

What is the cubic foot size of the freezer on my Kenmore side-by-side refrigerator model 253.54624408?

A:

The total cubic foot size of this model is 26. You have 9.48 cu. ft. capacity in the freezer. The refrigerator has 16.48 cu. ft. capacity.

Read More
Lyle W -
Sears Technician
July 23, 2008

Top Parts