Model #25351232104 KENMORE Side-by-Side Refrigerator

  • Freezer Door
    3 Results
  • Refrigerator Door
    3 Results
  • Cabinet
    3 Results
  • Shelves
    3 Results
  • Controls
    3 Results
  • System
    3 Results
  • Dispenser
    3 Results
  • Ice Container
    3 Results
  • Ice Maker
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Is the location of the evaporator cover at the bottom of the freezer?

A:

The evaporator cover for your model is the lower cover panel located at the rear of the freezer.

  • An ice build-up is usually caused when the freezer fails to go into a defrost cycle.
  • Frosting or icing can also be caused if warm outside air is leaking into the freezer. Check the door gasket to see if it's making a tight seal next to the cabinet.
  • If the icing is occurring on the floor of the freezer it's usually related to a drain problem.
  • It can also be from the ice maker if there is a leak during the fill cycle.
This is a problem you may need to have a technician check to make the necessary adjustments or replace a part. If you need more assistance you can resubmit your question with additional details.

Read More
Scott D -
Sears Technician
November 21, 2008
A:

Where is the evaporator cover for the Kenmore 795.7203?

Read More
Darren -
August 29, 2013
See more answers
Q:

I replaced my fridge ice and water actuators and now the water does not work and the ice is constantly dispensing

A:

It can be extremely aggravating when your dispenser on your refrigerator will not work, even after replacing parts. I would suggest that you provide a little more information such as the make and complete model number of your product, so your expert will be able to provide you with the best possible answer. Just click on reply down below, where you can provide the additional information.

Read More
Julio -
November 15, 2012
A:

It is a Kenmore model 25351232104

Read More
tamara -
November 15, 2012
A:

Thank you for the model number.

It is disappointing when a repair does not work out. The actuator may not be releasing properly keeping the switch activated. Sometimes the switch contacts will stick. The control board could be defective or there could be a short in the wiring.

I would recommend using the images below to recheck the actuator parts. Pay special attention to the actuator switches. Make sure the wiring is connected and no visible damage. Voltage checks may need to be made on these parts to find the problem.

Please reply if further assisitance is needed. Thank you for using Manage My Life.

Read More
Barbara H. -
Sears Technician
November 16, 2012
See more answers
Q:

ice dispenser on kenmore refrigorator releases to much ice at one time. when freezer door is openned and closed the ice dispenser let ice come down in shoot

A:

Nobody wants a bunch of ice shooting at them when they go to get some ice cubes. So I understand your concern. Below I have attached some links that may help you with your situation. I hope these links are helpful!

Read More
Jackie S -
March 25, 2011
A:

I'm sorry you are having this problem. You have received some good information but it will not pertain to this problem. I suspect you mean the dispenser is dispensing too much ice and it�s falling out of the container. There is a deflector # 240507202 that can be added to the front of the bucket. This will help prevent the auger from pushing ice cubes through the front of the ice container. It's available at SearsPartsDirect . I'm attaching a picture of this deflector and where to install it. I hope this will help you. Thank you for using Manage My Life.

Read More
Scott D -
Sears Technician
March 26, 2011
A:

THANK YOU Scott D. I looked everywhere for a diagram of where the deflector was located. I could not even find it on the mfg web site. That deflector was a mystery to me. haha Thanks again.

Read More
Joe -
June 21, 2011
See more answers

Top Parts