Model #25344733102 KENMORE ELITE Upright Freezer

  • Door
    3 Results
  • Cabinet
    3 Results
  • System
    3 Results
  • Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

ice forming in bottom of freezer 25344733102 Kenmore Elite Freezer

Q:

Exterior Stainless Steel Freezer Door 25344733102 Kenmore Elite Freezer

A:

Thank you for choosing SearsPartsDirect.com. I will be more than happy to assist you. I can understand any frustration you may have experienced with regards to your unit. Let’s see what we can do for you.

I would suggest useing rubbing compund and sand paper between 1000-1200 grit. Rub in same direction as the grain of the brushed steel and use LOTS of elbow grease. This will take a while but the hard work will pay off and the SS will look like new. Use Vinegar to remove the grease from the compound and see the final product.

Hope this information has helped you. Again, thank you for choosing SearsPartsDirect.com.
 

Read More
JeffwallaceIII -
Sears Technician
January 20, 2015
Q:

replaced condenser fan motor but fan didnt come on. 253.44733102

A:

Thank You for choosing Sears PartsDirect.com. It is unfortunate to hear that you are having issues with your fridge and I do understand your frustration. Glad to help out. I'm looking at your model number 25344733102 and if the compressor is running, the condenser fan should also be running. If not, when making this voltage check, make sure the wires are connected, do not disconnect the wires. Be very careful making this check. The condenser is wired directly in with the compressor, so if the compressor runs, the fan will also. If there is no voltage to the motor but the compressor is running, I suggest checking the connections, where it connects, with the compressor. When the compressor is running but not the motor, it usually means the motor is defective. I hope this will help you. If you would like more assistance, any additional details will be helpful and I will be glad to assist you further. The condenser fan should run whenever the compressor is running. In other words, when the compressor runs the condenser motor should also run. Check to see if the compressor is running and if it is and the condenser motor is not running it could be wired incorrectly, there could be a broken wire somewhere or the new motor is defective. If the compressor is not running, the thermostat may be off or it could be in a defrost cycle. If it's in a defrost cycle, the unit will be off, for approximately 20 minutes.  If there is no voltage to the freezer/evaporator fan then I would suggest you check and confirm the thermostat is closed. There might be times the fan wouldn't run but if the control thermostat is closed then there should be 120 volts. I hope this information helps with your troubleshooting. If you have further questions please resubmit your question for further information.
 
Thank you for choosing Sears PartsDirect.com.
 
 
 
SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Sherman_G_Wallace -
Sears Technician
August 01, 2014

Top Parts