Model #25344303400 KENMORE ELITE Side-by-Side Refrigerator

  • Freezer Door
    3 Results
  • Refrigerator Door
    3 Results
  • Cabinet
    3 Results
  • Shelves
    3 Results
  • Controls
    3 Results
  • System
    3 Results
  • Ice & Water Dispenser
    3 Results
  • Ice Container
    3 Results
  • Ice Maker
    3 Results
  • Wiring Schematic
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Question and Answers

Q:

Ice maker not making ice 25344303400 Kenmore Elite Refrigerator

Q:

why doesnt the new water filter 9916 for kenmore 253.44303400 keep poping out of the base? 253.44303400 ; 9916

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your refrigerator. Upon researching model 253.44303400; I recommend you try to install the old filter to see if it fits ok if so exchange the filter that pops out for a new to see if it was just a defective filter. If the problem persists then I recommend you try using filter part#WF2CB.

I trust this information will help you, we appreciate your business thank for choosing Sears.

Read More
CarlosZ -
Sears Technician
March 16, 2015
Q:

How do you replace the water actuater? 25344303400 Kenmore Elite Refrigerator

A:

Thank you for choosing Searspartsdirect.com and being a valued member. I can certainly assist you in locating the instructions to replace the acutator on your refrigerator.

With the drip tray removed, remove the 2 screws at the bottom of the front panel just behind the sump opening.

Lift up on the front panel. There are 4 tabs (2 on each side of the front panel) that slide into slots on the door panel.

Swing panel out to side, being careful not to pull the ribbon connector for the control board. Carefully unplug the wire harness from the molex connector between the two gauge connections on the board by pulling straight up. Carefully unplug the ribbon connector from the power board on the dispenser in the door (see Figure 6). Now disconnect the green ground wire from the face plate. This will allow you to remove the face plate to service the gauges, user interface board, and button assembly.

To remove the dispenser assembly, remove the 3 screws on the front of the dispenser that go into the housing in the door. Then pull the dispenser out of the housing.Now disconnect the electrical connection on the left side of the dispenser power board.

Remove the water line from the dispenser housing by pulling straight out.

With the water line removed, the upper part of the dispenser is free of the freezer door panel. The main housing is part of the door panel, and is not removable.

The ice door and actuator switches, as well as the return springs, can be serviced with the control module removed.

You can also visit searpartsdirect.com for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day. 

Read More
Natasha12 -
Sears Technician
December 05, 2014

Top Parts