Model #25324462102 KENMORE Upright Freezer

  • Door
    3 Results
  • Cabinet
    3 Results
  • System
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Freezer Icing up on inside 25324462102 Kenmore Freezer

A:

Thank you for choosing Sears Parts Direct. I will be happy to help with your freezer. Upon researching model 25324462102; the first thing to check is to the door seal. Get a playing card and see if you can slide it in-between the gasket and cabinet. If air is leaking it will create frost build up. If that ok then then the defrost thermostat could need to be replaced. I linked a diagram below. The thermostat is number 20.

Thank you for choosing Sears. We appreciate your business. Have a great day.

Read More
Jeff Wallace Jr -
Sears Technician
October 27, 2014
Q:

kenmore model number 25324462102 leak outside

A:

It's great that your freezer is still working great. I found some information that would assist with your question, on how to unclog the drain hose. Hope this is helpful.

Read More
Yadira B -
October 10, 2012
A:

Thanks for the info, it's not really helping me with my model number, is there a video on how to do this? i dont know what the parts look like?

Read More
Randy -
October 10, 2012
A:

Anybody here to help still same problem

Read More
Randy -
October 10, 2012
A:

Thank you for the question about your Kenmore freezer; sorry to hear there is a problem. I will be glad to assist you with this issue.
Based on your descriptio0n of the water leak I believe that the defrost drain trough id clogged.
To access this drain trough you must remove the back panel, inside the lower section of the freezer.always disconnect power supply to appliance before servicing Once you have the panel off with the fan motor you can see the drain trough just under the evaporator coil. be careful of sharp metal on and around these parts
Usually warm water will melt all the ice then you can un-clog. There is a drain tube that runs from the bottom of the trough down to a pan under the unit; this sometimes needs to be flushed with water or air pressure. After cleaning, reassemble in reverse order. If this reoccurs you may want to put a drain probe on the heater that hangs down into the trough and tube to keep ice from forming, this would only help if it is e clogged with ice, not debris. I hope this helps you solve this problem, if you need additional help reply with details and I will respond as soon as possible.

Thanks Ron H.
If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Ron H -
Sears Technician
October 11, 2012
A:

Ron so is this panel all one piece or can i just remove the bottom somehow? Now i dont know what these parts look like and this evaporator coil being sharp and being careful... Where do i get a drain probe to put on the heater? do i just set it on the heater? Again im not familiar with these parts, anyway you can shoot a video or pics of my model freezer to show me?

Read More
Randy -
October 11, 2012
A:

also you're talking about reassembling in reverse order, am i suppose to take everything apart?

Read More
Randy -
October 11, 2012
See more answers

Top Parts