Model #247370160 CRAFTSMAN Walk Behind Lawnmower, Electric

  • Rotary Mower
    3 Results
  • Decals
    3 Results
Find part by diagram >

Question and Answers


Can my mower be fixed ? 247370160 Craftsman Electric mower


Thank you for choosing Sears Parts Direct. I will be more than happy to help you with your lawn mower. Upon researching model 247370160; I show the motor bracket is key number 2 in the diagram. Click here for the diagram.

Thank you for choosing Sears. We appreciate your business and have a great day.




Read More
Jeff Wallace Jr -
Sears Technician
July 26, 2015

How to remove plastic cover off electric mower?


I understand that you want to take off the plastic cover from your electric mower. While you are waiting for an expert to respond, I have attached some helpful links below that may provide information to assist you with your question. Have a great day!

Read More
Alina F. -
May 29, 2012

Hello Keith,

I am glad that you asked for instructions instead of risking the breakage of the mounting tabs-good job! It is also great that you are taking the time to clean out the debris. It can cause excess heat and shorten the life of your mower. I have attached an excerpt from the service manual with instructions on removing the motor cover at the end of this reply.

Sears Parts Direct is a direct link to your model if you would like any parts.

Please let me know if I can assist you further.

Jerry C

Read More
Jerry C -
Sears Technician
May 31, 2012

Jerry - I don't see the service manual link in your post, would you send that again? Same question as Alina - how to remove shroud without breaking plastic tabs. Or better, post the entire service manual? Kurt

Read More
Kurt -
May 31, 2015
See more answers

Engine won't start 247370160 Craftsman Electric mower


Thank you for choosing Sears Parts Direct.
Upon researching model 247.37034 I show it has engine 126M02-6863-F1247.
To completely drain take I would recommend removing tank from unit then fully draining as well as cleaning with a cleaner. If not able to remove tank a siphon would help but might not drain all the way. Possibly draining oil so none leaks out. Then siphoning gas followed by tipping mower to have gas flow out lines.
If it has been sitting with gas then it might not be the tank or lines that's the problem but more so with the carburetor being that it has small air holes that can get clogged. If your going to clean the tank I would say go the whole way and remove carburetor and clean if possible. The carburetor might have to be replaced if to gummed up.
I did find a primer on the side of the air filter housing. I sent a link for the diagram and 976 is the correct part. I would check engine model to make sure everything is matching up for primer. The cleaning of carburetor and tank is similar for all units. Please verify engine model before purchasing carburetor if needed.

Click here for diagram.

Click here for carburetor.

Click here for air filter housing.
The picture is showing the back of the hosing so the primer is on left side of picture. If standing in front of air filter housing it should be on the right hand side.

I hope this helps you. If you have any further questions please comment back. Have a great day.

Read More
Samantha A -
Sears Technician
May 07, 2014

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show