Model #2467 SKIL Drill Driver

  • Cordless Drill Driver
    3 Results
Find part by diagram >

Question and Answers

Q:

Why is the rinse aid not dispensing in my Kenmore dishwasher?

A:

The rinse aid dispenser operates on a mechanical linkage assembly. If all of the dispenser linkage assembly #’s2-4-6-7 & 8 are in position I recommend replacing the rinse aid dispenser reservoir #5. After removing the outer door panel you will be able to see the reservoir & linkage assembly. As you turn the timer you will see the linkage lift up to release the soap cup while simultaneously charging the rinse aid dispenser. Please see the images provided for more details.

Read More
biker dave -
Sears Technician
July 22, 2009
A:

I have the same problem with a 587.15103801. I removed the cover and manually cycled the rinse aid mechanism. The first cycle it appeared to be stuck, then it squirted loudly. Then it moved freely. It appears to be metering the rinse aid properly now. I'm not sure what position the two way link should be in now to cycle properly.

Read More
kevin -
August 26, 2013
See more answers
Q:

What are the appropriate temperature and pressure settings for boiler?

A:

The temperature setting for your boiler depends on a number of factors. As you will read in the linked articles, some boilers maintain no minimum temperature. They simply start up when there is a demand for heat. Other boilers are installed with zone thermostats that control circulating pumps. The boiler temperature is maintained at a constant, and the thermostats simply control the pumps which moved the heated water to the desired location(s). My own boiler has a minimum temperature setting, simply because of the size of the boiler and the lag time involved in bringing the boiler up to temperature. This minimum temperature is a function of the size of your boiler, the size of your house, and the heat loss from your house. The optimum setting can only be arrived at by experimentation. My personal experience is that the minimum boiler temperature should vary through the heating season. If I set my boiler temperature to where it should be in January and February (140F), my house overheats in November and March. In years when I'm lazy, I just leave it at 120F. From the information that you have provided, you also have a very large boiler, and may find yourself in circumstances similar to my own. The high temperature setting, and the pressure setting, have nothing to do with operating the boiler. These are safety controls to shut off the boiler if the temperature or the pressure get too high. They are typically set at 210F, and 30 psi.

Read More
expert -
Sears Technician
April 26, 2007
A:

I have a riello 40 F5 burner and a WBV 04-125 peerless boiler. 3 zones. Oil tank is under ground 550 gallons. 2 lines going into burner. My burner turns off after a couple minutes. had to hit reset button. I changed the nozzle 1.00, 60 degrees. clean it and clean electrodes.(black mark on one electrode partially little dent or burn mark). cleaned boiler and had chimney cleaned.

Read More
George Badillo -
December 07, 2012
A:

I have a riello 40 F5 burner and a WBV 04-125 peerless boiler. 3 zones. Oil tank is under ground 550 gallons. 2 lines going into burner. My burner turns off after a couple minutes. had to hit reset button. I changed the nozzle 1.00, 60 degrees. clean it and clean electrodes.(black mark on one electrode partially little dent or burn mark). cleaned boiler and had chimney cleaned.

Read More
George Badillo -
December 14, 2012
See more answers