Model #234795512 CRAFTSMAN Line Trimmer/Weedwacker/Brushwacker

  • Drive Shaft Housing
    3 Results
  • Rope And Handle Starter
    3 Results
  • Engine
    3 Results
  • Carburetor
    3 Results
  • New And Old Style Cutting Head Assembly
    3 Results
  • 3 Version Cutting Head Assembly
    3 Results
Find part by diagram >

Question and Answers

Q:

Where can I get a routing diagram for running new gas lines? 234795512 Craftsman Craftsman 26.2cc gas weedwacker

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Marc -
March 10, 2013
A:

Thank you for your question. I am sorry; we do not have written instructions for the routing of the fuel lines on your product. Our technicians are thought the basic routing because the routing cannot change much from year to year. If you have one large fuel line and one smaller this eliminates some chance for error. If you have 2 small fuel lines to the carburetor connect them and start the engine. Reversing the fuel lines will not prevent the engine from starting. If you have them connected backwards, the engine will start and die. Reverse them and you will be correct. The routing of the fuel lines vary from model to model. Keep in mind that the primer bulb circulates fuel from the tank, through the carburetor, and back into the fuel tank. One line goes from the fuel tank to the carburetor. One line goes from the fuel tank to the primer bulb, from the primer bulb to the carburetor, and back to the fuel tank. The small line in the fuel tank should have the filter attached to it. I have added a sketch below of how the fuel should flow in the circuit.    If you need further assistance, please submit more details.     If you do not feel confident repairing this problem yourself, then you can have it repaired by a Sears  technician.  Here is a link that will provide the nearest drop-off locations:  Sears Home Services.   Thank you for using Manage my life. Mark T.

Read More
Mark T -
Sears Technician
March 12, 2013
See more answers
Q:

weedwacker wont run

A:

First, make sure the new fuel lines are fully connected and not sucking any air anywhere. Based on your details if the fuel line is properly installed and it’s not sucking air then you will likely need to richen the fuel mixture by adjusting/opening the high speed needle valve/adjustment screw (key#19) and or the low speed adjustment screw depending if it will idle and increase RPM correctly when you squeeze the throttle. These adjustment screws are located on the side of the carburetor. See image below. Turn the high speed adjustment screw counterclockwise (CCW) about 1/2 of a turn and see if will run without the choke. If you’re not able to get the engine to run without the choke by adjusting the high/low speed adjustment screws then the carburetor will likely need to be removed a rebuilt.

Read More
Joey S -
Sears Technician
May 14, 2010
Q:

How do I get the head off of my Craftsman gas weedwacker?

A:

I have included an image below to assist you in removing the guard from your weedwacker.

You will note there are screws hidden on this guard. In the image below, key number 11 will need to be removed. Also remove key numbers 12, 16 and 17 to pull this guard off of the shaft.

For more help with this weedwacker problem, resubmit your question with additional details.

Read More
Carpentry Bucket -
Sears Technician
September 30, 2008