Model #23359966400 KENMORE ELITE Range Hood

  • Down Drafter Ventilator
    3 Results
Find part by diagram >

Question and Answers

Q:

Cutout dimensions

A:

Wanting to know the cutout dimensions for your Kenmore Stainless steel Range. While you are waiting on an expert to response to your question, You can visit Sears.com website and speak with a Sears associate. I attached the link below. Hope this helps! Good luck. www.sears.com

Read More
Dezeray S -
October 30, 2010
A:

The first image below provides cut-out dimensions for the top of the counter. The full Kenmore model number of this range hood is 233.59946590.

Here is a link for the full installation guide for this model: Use & Care/Installation Manual .

I also provided additional information from a contractor's specification sheet for a similar model of range hood that should have the same dimensions (233.59966400). This additional information may be useful.

If you need more help, reply with additional details and we will assist you further.

Read More
Lyle W -
Sears Technician
October 31, 2010
See more answers
Q:

kenmore elite downdraft

A:

I understand how inconvenient it can be to have downdraft blower is not working properly. While you are waiting for an expert answer, I did manage to find a link that will provide you with more information about your problem. I hope my link is useful.

Read More
Joseph P. -
September 21, 2010
A:

The link for a previous answer provided by Joseph P. above correctly indicates that a bad switch could be causing this problem. The image below shows the wiring diagram and access information for the switch. Be sure that you disconnect electrical power to the downdraft blower (unplug it or shut off the breaker) before accessing this switch. The switch may just need to be adjusted as shown below. If that does not help, then you can check the continuity through the switch with a volt/ohm meter. With the switch not activated, it should be "open" (measure Ol -- open load or infinite resistance) between the leads that are connected to the blue and yellow wires on the switch. If you measure continuity (near zero ohms of resistance) when the switch is not activated then it will need to be replaced.

These tips should help you fix this failure in the downdraft blower. I you need more assistance, reply with additional details.

This type of downdraft blower is not that easy to repair. If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
September 22, 2010
See more answers