Model #2335548910 KENMORE Range Hood

  • Range Hood
    3 Results
Find part by diagram >

Question and Answers

Q:

how do I R & R this part touchpad #97013466

A:

Good afternoon.... I was unable to locate any information using the part number you provided us. It would be very helpful if you could include your full model number. Could you also send us more information on what's going on currently? Please respond to this thread and we will get back to you quickly. Until we hear from you, have a nice day.

Read More
Henry -
January 13, 2013
A:

I have a Kenmore range hood mod 233.5548910 I have a new touch pad and would like to know how to R & R ti thank you. Dan

Read More
Danny -
January 13, 2013
A:

Hi Thank you for the help. The mod # is 2335548910 Kenmore hood not sure what year of manufacture is.

Read More
Danny -
January 14, 2013
A:

There is not a procedure available for the replacement of the touchpad on that older Kenmore range hood. These general tips may help you complete that repair:

Shut off the house circuit breaker to disconnect electrical power and remove the filter on the side that has that touchpad. You may be able to disconnect that wires and pull that touchpad out after removing that filter. If not, then you may need to remove the blower motor and/or other components. The owner's manual/installation guide will normally provide directions for removing the blower motor. You may need to pull the range hood down to access that touchpad. You can view the parts image for the blower on this page: Kenmore Range Hood Model 233.5548910 Parts . The parts diagram may help you access and replace that part.

If you get to the point where you need to have a service technician replace that touchpad, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
January 15, 2013
A:

Here is the image.

Read More
Lyle W -
Sears Technician
January 15, 2013
See more answers
Q:

How do I turn off a shrill twitter sound that started in my Kenmore Hood coming from the heat sensor?

A:

From what you described I suspect the control board. The control board has a warning buzzer that if the control area starts overheating past 65 degrees C. the buzzer will come on until the area cools off. The sensor on this model is built onto the control board. I recommend replacing the control board assembly.

Read More
biker dave -
Sears Technician
November 07, 2009

Top Parts