Model #20510 KENMORE Faucet

  • Unit Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

jenn air gas slide in range

A:

It can be very frustrating when the broiler ignitor on your range begins to fail. I did some research and provided a link to a similar question and answer on our site. I hope this will shed a little more light on the issue until the Expert responds to your question in more detail within 24 to 48 hours.

Read More
Julio -
November 03, 2012
A:

Thank you for your question and I understand your concern.

I must assume the broiler glow bar igniter is not glowing or the igniter is glowing but it is too weak to pull enough current/amperage to open the oven gas valve. Start a broil cycle and see if the glow bar igniter will glow red or not. If it glows, the igniter is too weak to pull enough current/amperage to open the gas valve. If the igniter will not glow, the igniter could be broken or it could have faulty electronic oven control or a faulty gas valve assembly.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
November 05, 2012
A:

The igniter does not glow at all and there is no discernable heat coming from it when the broiler is started. All other range and oven functions seem to operate appropriately. Is there a way to test whether the problem is with the igniter prior to buying a new one and installing it?

Read More
David -
November 05, 2012
A:

David: You disconnect the wires from the igniter and use an Ohm meter to check for continuity across the two wire leads. If it does not measure any continuity, replace the igniter. The igniter must have a 120 volt power source before it will glow red. If the igniter measures continuity, I would suspect a fault electronic control board. If you have experience and feel safe and confident in measuring the voltage supply across the two wires connected to the igniter, check the voltage supply when programmed for broil. If voltage is present, replace the igniter. If the voltage (120) is not present, replace the electronic oven control/clock assembly. Disconnect the power cord from the power source before disconnecting and removing the broil igniter.

Read More
Joey S -
Sears Technician
November 05, 2012
A:

Thank you, Joey. You've been very helpful.

Read More
David -
November 05, 2012
See more answers
Q:

how do the wires get reconnected to the starter relay on lg refrigerator lrbn20510ww?

A:

Managemylife.com is always a great resource to find the answers to just about anything. Your expert will research your question and respond within two business days but usually sooner. Have a great day!

Read More
Alina -
September 07, 2012
A:

Hi,

Thank you for your question. It is concerning when the refrigerator is not functioning correctly.

Here is the wiring for the ptc relay, I should plug on the compressor and the wires should be like this: The black wire goes through the overload protector to common C on the compressor. From the compressor M is hooked through the pct pins 2 and 5 to the blue wire, which is the neutral wire. The compressor S id tied to the red wire and ptc terminals 4 and 5. If there are capacitors, pink wire is tied to terminal 3, the red is ties to the other terminal of the capacitor. Red is also ties to the other capacitor and the blue is tied to the same capacitor. Follow the diagrams See Below.

Always unplug or de-energize electrical equipment before removing covers or attempting service. Be careful and wear appropriate hand protection when working around sharp metal parts.

I hope this is helpful. If I may be of further assistance please include more details in a reply to this entry below.

Read More
Bill__W -
Sears Technician
September 10, 2012
See more answers