Model #20204 SHARP VCR

  • No Image Available - Wards
    3 Results
Find part by diagram >

Question and Answers

Q:

capacitor for drill press

A:

I know this type of information can be very helpful for you to have. While you are waiting for your expert answer, I did some research on the unit. I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within 24-48 hours with detailed information. Thank you for using Manage My Life.

Read More
Yadira B -
September 13, 2012
A:

Thank you for your question on the replacement capacitor for the drill press motor.

The manufacturer did not list the capacitor values or part numbers for the 8F15A20204 motor on the drill press. This motor is no longer available for the drill press.

If you do not have the original capacitor and the specifications for that capacitor you would have to go to an electric motor shop to see if they can figure out what capacitor would work.

I have tried to get the values of the capacitors but they did not have that information.

The drill press was made by Rexon for Craftsman.

You may have to find a replacement motor for the drill press. It was listed as a 1/3 hp motor at 120 volts ac.

I am sorry that I was not able to help you with this request.

Sam A.

Read More
Sam A -
Sears Technician
September 14, 2012
A:

Thanks Sam...any other experts wanna give it a try?

Read More
john -
September 14, 2012
A:

I have the same drill press, judging by the picture in the a.PDF manual. The motor suddenly quit on mine. It spins slowly with no power. The capacitor is 16uf, 250 volts. It has "CBB60" printed on it. EBay and Amazon list several, but they are all physically larger than the original, and will not fit in the cover. Duct tape to the rescue. It is ok if the voltage rating of the replacement is higher than 250 volts.

Read More
Dennis -
May 27, 2015
A:

I received the replacement capacitor which I ordered from Amazon, and am happy to report that the motor now runs fine. http://www.amazon.com/gp/product/B00B14PPZ4?psc=1&redirect=true&ref_=oh_aui_detailpage_o05_s00 The replacement capacitor is too big, but I found a mounting solution that is better than duct tape. The diameter of the capacitor is such that it will fit in the can if you omit the spacer that is used with the factory capacitor. It is just too long. So I cut off the top of my can, letting the capacitor stick out the top. The bottom of the can is still secured with the factory screw. I put a long zip tie around the whole motor to secure the top of the can. I finished the job by writing the value of the capacitor on the motor in case the capacitor ever burns up.

Read More
Dennis -
June 01, 2015
See more answers
Q:

I have a craftsman drill press model 8F15A20204. I am looking for specifications for the motor since it is no longer available from sears

A:

Thank you for your question though I am afraid I was not able to bring up any information on the drill press motor.  Most are 3/4 horsepower.   I did find the motor on ebay but it had already been sold.   I believe replacing the drill press is your best option.  Do you have the model number for the drill press.  You have the motor number but I may be able to pull up more information is a model number is provided. 

Read More
Fred M -
Sears Technician
November 25, 2013