Model #1CWTW5100VQ1 WHIRLPOOL Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Controls And Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts
    3 Results
  • Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

spinning problem 1CWTW5100VQ1 Whirlpool Automatic washer

A:

The Managemylife web site is a good resource of information to find out what may be happening and what options are available to you. I'm sorry to hear about the difficulties with your Whirlpool washer leaving the larger clothes wetter than it should. I did some research at Managemylife website and found this expert answer to a similar question that may help until your expert can respond. I have attached the link below so you can check it out. I hope this helps you Jose.

Read More
James -
February 09, 2013
A:

Hello Jose

I'm sorry to hear that you are having problems with your washer and I would like to assist you. The description of the problem appears to be from an oil leak on the output shaft seal. I have repaired several of these with the exact same weak spin symptoms and it was due to oil getting on the clutch, from the leak in the seal. I have attached an image with notes on it to explain this issue. Prior to servicing your washer, be sure to unplug it. Remove the washer cabinet and look closely at the clutch for signs of wetness or oil. Many times, there will be oil that has been flung off of the clutch and onto the insides of the legs that support the assembly. If this is the case, It is far easier to replace the transmission than it is to attempt to replace the seal.

Please reply with what you find and I'll be happy to assist you further.

Jerry C

Read More
Jerry C -
Sears Technician
February 09, 2013
A:

The images did not post correctly, re-posted on this reply.

Jerry C

Read More
Jerry C -
Sears Technician
February 09, 2013
A:

Thank you for your question and I understand your concern.

Based on your symptom and details you could be possibly putting too large a load in the washer or if you're using too much HE detergent or using the wrong kind of detergent can also cause draining and spinning issues. The washer will not spin if it senses oversudsing and it will not spin up to speed if it senses and off balanced loads.

Also check your load selector. If you have it set to delicate load, the spin cycle is at slower speed. The only other option is if the drain pump in clogged, it could draining a lot slower rate, which can leave a lot of water in the drum on larger loads. I will include the link to our PartsDirect page for the drain pump.

 

Drain Pump for Model 1CWTW5100VQ1

 

Read More
Desirea -
Sears Technician
February 09, 2013
See more answers

Top Parts