Model #1844 CRAFTSMAN Cultivator

  • Replacement Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Craftsman GT 18/44

A:

I know how useful detailed instructions can be when making some major repairs. While you are waiting for your expert answer, I did some research on the tractor. At this time, I was unable to locate information that would be helpful in regards to your question. Your expert will answer within 24 to 48 hours with detailed information. Thank you for using Manage My Life.

Read More
Joseph P. -
December 29, 2011
A:

Thank you for your question.

I will be happy to assist you. I have looked up the model numbers you have submitted. I am sorry the snow blade will not fit your tractor. The reason is the tractor does not have the front hanger brackets for the blade. The blade I show for your tractor is 486.24414.

Please let me know if you need further assistance.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
December 30, 2011
See more answers
Q:

Craftsman GT 18/44

A:

Managemylife.com is always a great resource to find the answers to just about anything. Your expert will research your question and respond within two business days but usually sooner.

Read More
Alina F. -
December 29, 2011
A:

Thank you for your question.

I will be happy to assist you. I have looked up the model numbers you have submitted. I am sorry the snow blade will not fit your tractor. The reason is the tractor does not have the front hanger brackets for the blade. The blade I show for your tractor is 486.24414.

Please let me know if you need further assistance.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
December 30, 2011
See more answers
Q:

Temperture suddenly rises, freezer #'s blink when rising in heat, have to unplug & plug in, but normal temp won't remain, I have replace the temp sensor #DA47-E

A:

I can see your looking for a list of parts, and some specific information that the expert will give you. While your waiting on an expert answer, you can visit Sears Parts Direct website and put in the model number that will show you the diagrams and a list of the parts. I attached the link below, I hope this helps!!!!!!!

Read More
Raquel F -
September 21, 2010
A:

From the description listed, it sounds like the main board has failed. When you unplug and reconnect the power it resets the board. This can be a very difficult product to check and I recommend having a technician check it. However, if you would like to check the sensors, the main board behind the unit will need to be accessed. First disconnect power to the unit. When you have access, to the board, locate connector CN30 (see attached picture) and disconnect it. Check the resistance from the blue wire that was on pin 1 to the gray wire that was on pin 5. Now use the chart attached to determine if the resistance is correct in relation to the temperature in the freezer. You will need to check the temperature in the freezer, with a thermometer placed between some packages. If the resistance is off more than 5 % replace the sensor. You can also plug the connector back in and make a voltage check using the diagram. This will be dc voltage. If it’s not correct, the board will need to be replaced. I hope this will help you.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Scott D -
Sears Technician
September 22, 2010
See more answers