Model #153324811 KENMORE Water heater, Electric

  • Non-functional Replacement Parts
    3 Results
  • Controls Group
    3 Results
Find part by diagram >

Question and Answers

Q:

Water heater replacement anode rod

A:

I know this type of information can be very helpful for you to have. While you are waiting for your expert answer, I did some research on the unit. I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within 24-48 hours with detailed information. Thank you for using Manage My Life.

Read More
Priscilla V -
December 04, 2011
A:

Thank you for your question.

I will be happy to assist you. I have looked up the model number you have submitted. I believe the 9001829 will work for you. The only problem might be the length of the rod. The 9001829 might be a little longer than the original. If you find that it is too long, just cut it to length with a hacksaw. Please make sure to apply Teflon tape to the threads before installing it.

Please reply below with more details if you need further assistance.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
December 06, 2011
A:

Hi, how wide is the Inode rod? can I buy it at menards? I took my inode rod out and it was only about 1/4" thick all the way down. I think it should be about 3/4" thick but nothing bigger than the 1/4" rod fits inside the top of the hole? please help!?

Read More
Bacard100 -
January 07, 2013
A:

I am sorry you are having a problem with the anode rod. The hole in the tank for the rod should be the same size as the threads on the anode rode. I suspect the hole has closed up over the years. You can try to open the hole by reaming the hole with a large screwdriver. Once the hole is cleaned up you can install the new anode rod. The new anode rod will be a little smaller than the threads on the rod. I hope this is helpful. Please let me know if you need further assistance. Thank you for using Manage my life. Mark T.

Read More
Mark T -
Sears Technician
January 08, 2013
See more answers