Model #153320560 KENMORE Water heater, Electric

  • Electric Water Heater
    3 Results
Find part by diagram >

Question and Answers

Q:

model 153.320560 Ht is not delivering a lot of hot water. Need new heating elements but Ihave no manual 153320560HT Kenmore Power miser 10+

A:

Thank you for your inquiry on your Kenmore Water Heater, Model: 153320560HT. From reviewing the details on your model, if this is electric it could be one of the elements is not coming on. This could be caused from the thermostat not switching or the element itself could be open. if the incoming water is colder than normal it can create this problem or it could be a cracked or broken dip tube.

Safety Warning: Before beginning the repair, disconnect the direct power supply to the water heater to prevent the risk of injury or any electrical shock.

If you don’t feel comfortable or confident in this repair, then you can have it repaired at home by a sears technician. I have the included a link to the website: Sears Home Services or call 1-800-469-4663.

 

I hope this answered your question. Thank you for contacting SearsPartsDirect.com, and have yourself a wonderful day. 

Read More
Gerry 93 -
Sears Technician
June 01, 2015
Q:

I m looking for a wiring schematic for a 153.320560ht

A:

Wiring schematic come in very handy when rewiring any product, like the Kenmore water heater . An expert will research for a wiring diagram on the water heater and respond within two business days. Thanks for your patience.

Read More
Anna T -
November 04, 2012
A:

Thank you for your question. I know it can be frustrating when the hot water heater isn�t working. I�m attaching a picture of a typical electric dual element water heater. I hope it will help you. If you would like more assistance, reply to this thread and I will be glad to assist you further.

Read More
Scott D -
Sears Technician
November 05, 2012
See more answers
Q:

kenmore water heater

A:

Making repairs with good instructions can save us money if not time. I was not able to locate the owner's manual for your unit but did find the schematics and attached them below. I also found some general how to steps at a web site. These may help while you wait for the expert answer.

Read More
Barbara H. -
July 29, 2010
A:

First disconnect power to the water heater. There is a special socket # 9000429015 to remove the element that I recommend getting. It's available at SearsPartsDirect . A similar socket may be available at a local hardware store. Now shut the water supply valve off to the water heater and connect a water hose to the drain fitting. Open the drain valve and keep the water hose as flat as possible, to help the water drain easier. Also open the pressure relief valve to help it drain faster. Draining a tank can take a long time (2 – 4 hrs) and sometimes longer. Take the wires loose from the element and when the water level is below the element you want to replace, unscrew it with the socket (wrench) and remove it. Screw the new element in place (do not over tighten it) and reconnect it. Close the relief valve now and open a hot water faucet. Fill the tank with water before turning the power back on. Failure to do this can burn the element out. When the faucet stops sputtering and the water is flowing good turn the faucet off. Now you can turn the power back on. I hope this helps you.

Read More
Scott D -
Sears Technician
July 30, 2010
See more answers

Top Parts