Model #153318360 KENMORE Water heater, Electric

  • 30 Gallon Model
    3 Results
Find part by diagram >

Question and Answers


Why don't I have any hot water?


First, check for a tripped breaker. If the breaker is ok, the next check will be the reset button on the top thermostat. First disconnect power to the water heater. Remove the top access cover and carefully pull back the insulation. You will now see the thermostat with a cover over it. There will be a small button about the center of the thermostat, you can push. If it clicks when you push it, this indicates that it was tripped. Replace the cover and turn the power back on. You should hear a hissing type noise now, which indicates it's heating the water. If nothing happens and you still don't have hot water after a couple of hours, a technician will be needed to make some voltage and resistance checks. If you need more assistance, you can resubmit your question with more details.

Read More
Scott D -
Sears Technician
December 22, 2009

Top Parts