Model #14506 KENMORE Humidifier

  • Unit Parts
    3 Results
Find part by diagram >

Question and Answers


Vacuum Hose Removal from End Pieces


Having to remove pieces on an Vacuum can get a little frustrating with out instructions. While you are waiting on an expert to response, I found the owner's manual for your Vacuum. I attached the link below. Hope this helps!

Read More
Dezeray S -
November 01, 2010

Thank you for your question.

I can understand you wanting to fix your vacuum hose yourself. This is not hard if you know what to do.

� First you will need two small pocket type flat blade screwdrivers.

� Next locate on the hose the molded seam line in the rubber sleeve on the hose cuff.

� As shown in the picture below, find the gap in the cuff where it meets the elbow and insert and slide the screwdrivers in about a 1 inch along the seam line on both sides to release the tabs that hold the cuff on.

� Once released use both you hands to pull the cuff down the hose off of the elbow connection.

� You will then see the wires that come from the hose connecting into the elbow.

� Release the wires from there connection sleeves and release the plastic tab the hold the elbow to the hose.

� Remove the elbow and cuff from the old hose.

� Slide the cuff onto the new hose and install the elbow onto the new hose until it locks into position.

� Re-connect the wires from the new hose to the connectors on the elbow.(make sure you have them into there respective locations)

� Pull the cuff up the hose until it latches onto the tabs.

� Do the same for the other end of the hose.

I have sent some pictures below to help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
November 01, 2010
See more answers

Top Accessories