Model #13AM762F765 MTD Lawn, Tractor

  • Hood/grille 760 & 770
    3 Results
  • Grille/hood - 761 & 771
    3 Results
  • Grille/hood - 762 & 772
    3 Results
  • Grille/hood - 769 & 779
    3 Results
  • Seat/fender - 760-779
    3 Results
  • Steering 760-779
    3 Results
  • Transmission 760-779
    3 Results
  • Frame Assembly 760-779
    3 Results
  • Housing/brake 760-779
    3 Results
  • Deck/chute 760-779
    3 Results
  • Deck Chute 760-779
    3 Results
  • Engine 760-779
    3 Results
Find part by diagram >

Question and Answers

Q:

Yes I have a bolen lawn tractor

A:

Manage My Life.com is a great site to get troubleshooting advise and specifications. A expert will reply within a 24 to 48 hour period.

Read More
maira -
July 27, 2013
A:

If you look on the right side of the transmission, you will find the brake assembly. There is a little lever on the brake assembly and a nut that holds it there. Tighten that nut by a turn or so and see if the brakes work better for you. If they do not, you may need to take the brakes down and replace the pads.

Thank you for using Manage My Life!

Read More
Wade_B -
Sears Technician
July 28, 2013
See more answers
Q:

i have a tractor that gas goes into the oil tank why is this happening?

A:

I'm sorry to hear that you are having some difficulties with your Tractor. I did some research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. I hope the link provided assist you.

Read More
Priscilla V -
October 26, 2011
A:

Thank you for the question.

I am sorry you are having a problem with the tractor. If you find gas in the oil, it is because the carburetor is not regulating the fuel level in the float bowl. We usually find that a piece of debris is stuck in the fuel inlet so the fuel flow is not controlled. The cure the problem you will need to remove the fuel line first. Then remove the float bowl and float. This will give you access to the fuel inlet. Flush the fuel inlet by spraying carb cleaner into the hole where the needle goes. Once it is cleared out, reassemble the carburetor, and install new fuel line. Before you start the engine, change the oil and the filter if your engine has one.

I hope this is helpful. If you need further assistance on the engine, please reply below with the model number of the engine.

Here is a link to order any parts you need. Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
October 27, 2011
See more answers

Top Parts