Model #13953765 CRAFTSMAN Garage Door Opener

  • Radio Control
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Can another transmitter be added to a Craftsman 139.53765 receiver already paired with a 139.53778 transmitter? Craftsman 139.53765 receiver

A:

Thank you for choosing SearsPartsDirect.com. I will be more than happy to assist you. I can understand any frustration you may have experienced with regards to your unit. Let’s see what we can do for you.

The only way that another opener can be added would be if the unit is compatible to the transmitter. And you’re able to connect more than one transmitter. To check all that information you would refer to your owner’s manual.

Hope this information has helped you. If you are not comfortable doing this repair you can click here to schedule a technician or call toll free 1-800-469-4663. Again, thank you for choosing SearsPartsDirect.com.

 

Read More
JeffwallaceIII -
Sears Technician
June 02, 2015
Q:

I have a remote 139.53765 I need the dip switch code. I can't find anything in the unit 139.654001 opener. Also the button on the wall is a plug in unit.

A:

I understand the need for the dip switch code. I some research on the model numbers but was not able to find information to help you. Your expert will be able to help answer your question. It may take two business days for your expert to reply. I do hope that everything works out on the Craftsman garage door opener.

Read More
Marc -
June 21, 2013
A:

I know that it can be very difficult to have issues with your garage door opener. On the back or the side of the motor head is a set of little white dip switches. This is where you can set your code. Inside the remote you will also have a set of these. These two sets just have to match to get the transmitter to operate the door. I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
June 24, 2013
A:

How do I send thbuilt into my care signal to my remote bt came with the door openeruilt into my car. I don't have a remote that came with the door opener? Where do I get a manual for 139.654001.

Read More
qvp -
March 11, 2014
See more answers
Q:

How do I reprogram my remote to my dip switch garage door opener?

A:

The Managemylife web site is a good resource to find out what may be happening with your Garage Door Opener. I did some research for you at Managemylife.com and found an excellent article that also has multiple expert answers at the bottom of the web page that addresses the most common questions that have been asked by other members. I hope this will help until your expert can answer your specific question. I attached the link below.

Read More
Priscilla V -
June 06, 2012
A:

Thank you for submitting your question. I was able to find the owner's manual for your garage door opener and your remote. Here is the owner's manual for your garage door opener and here is the owner's manual for your remote. These instructions should be able to help you sync everything back together. If you require further assistance, please reply back to this thread with more details. I hope this helps. Thank you for choosing Manage My Life.

Read More
Tykara -
Sears Technician
June 08, 2012
See more answers

Top Accessories