Model #13953672SRT2 CRAFTSMAN Garage Door Opener

  • Opener Assembly
    3 Results
  • Installation
    3 Results
  • Rail Assembly
    3 Results
  • Security & Standard Accessories
    3 Results
  • Hardware/extension Kits/bulbs
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

need wiring diagram for sensors 13953672SRT2 Craftsman Garage door opener

A:

This owner's manual shows the wiring for the sensors on page 23. Use that information to connect the safety sensors.

If you need more help, let us know.

Thanks for choosing Sears PartsDirect.

Read More
Lyle W -
Sears Technician
October 20, 2014
Q:

push button on wall wiring 13953672SRT2 Craftsman Garage door opener

A:

The terminals 1 and 2 are used to control the garage door opener according to the information in the owner's manual.  Connect the wires to the wall control using the information in that manual.

If you need more help, let us know.

Thanks for choosing Sears PartsDirect.

Read More
Lyle W -
Sears Technician
October 20, 2014
Q:

garage door opener does not open the garage door.

A:

Garage doors are an important privacy and security part of the home. The door malfunctioning would be a concern. I did some searching while you wait for the expert response and located a similar repair gone bad post for this model. I attached the link below. I hope this offers some help.

Read More
Barbara H. -
January 27, 2012
A:

Make sure you put the black cup back on the end of the motor shaft and that it is pressed all the way on. Make sure the RPM sensor is plugged in. If neither of these are the issue, then you probably did not have the motor shaft pushed all the way back when you tightened the coupler after replacing the worm gear. Loosen that coupler up and from the front of the motor (opposite end in which the coupler is on) push the shaft back as far as it will go. Hold it there while you tighten the coupler back up and then try it.

Read More
Don -
January 27, 2012
A:

Give Don's suggestions a try and see if that will get the opener back to operating as it should. In most cases where we run into this situation, one of those things will take care of the problem.

Let me know where we stand with this.

Thank you for using Manage My Life!

Read More
XX Wade_ -
Sears Technician
January 28, 2012
A:

Don and Wade, Thank you so very much for your help! The problem was the motor shaft was NOT pushed all of the way forward when I tightened the coupling. It was only about 1/8 of an inch off, but that made all of the difference in the world. Once I got that right, then my limit switch was way out, but that was easy to adjust. I had the door working perfect in less than an hour! Glenn

Read More
Glenn -
January 28, 2012
A:

@Glenn, That's great news! I'm glad you were able to get it back right again. Thanks Don for your suggestions. Once again you nailed it. We appreciate your input around here.

Read More
XX Wade_ -
Sears Technician
January 30, 2012
See more answers

Top Parts

Top Accessories