Model #13953660SRT1 CRAFTSMAN Garage Door Opener

  • Security & Standard Accessories
    3 Results
  • Hardware/extension Kits/bulbs
    3 Results
  • Installation Parts
    3 Results
  • Rail Assembly
    3 Results
  • Opener Assembly
    3 Results
  • Opener Accessories
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Programming new remote for Craftsman garage door openermodel #13953660SRT1 13953660SRT1 Craftsman Craftsman garage door opener

Q:

Can I change the motor for my GDO model 13953660SRT1 from a 1/2 to a 3/4 13953660SRT1 Craftsman Craftsman garage door opener

A:

Thank you for choosing SearsPartsDirect. I will be more than happy to assist you with your Craftsman garage door.  

From the information you have provided above, after researching model number 139.53660srt1. The motor is replaceable. The part# for the motor is 41D3058.

I hope you found this information useful. Again thank you for choosing Sears, we appreciate your business, have a great day.

*Safety disclaimer before you try and repair the unit make sure the power supply is disconnected. There may be sharp parts to the unit that can cause injury to you if not careful. If you don’t not feel comfortable checking this yourself you can request a technician by visiting www.SearsHomeService.com*

Read More
Benny23 -
Sears Technician
May 16, 2015
Q:

Craftsman GDO does not work properly after replacing plastic gear.

A:


The most likely problem is that the door lift mechanism or limiter switches are out of sync. The unit may be reversing before reaching the limit setting due to the mechanisms being out of sync and that triggers the flashing fault code.

There could also be some binding, either with the door lift assembly or at some point between the gears that were install that is also causing a reverse. There is additional information in the links below that should help with testing the issues you are facing.

A final issue could be with the logic board or motor itself, possibly an incorrect wiring connection or a connector hooked-up off center so not all the pins are reading. If nothing here or in the links helps you might be in need of a logic board or possibly the motor or another component which might have failed coincidentally.

Read More
expert -
Sears Technician
February 26, 2008
A:

If the force & limiter switches r out of sync, how do u get them back in sync. My thought was to pull the large plastic cable out of the logic board & put it back in place, hoping to clear the logic board, if that is where they r held out of sync?

Read More
frederick -
March 04, 2015
See more answers

Top Parts

Top Accessories